YWMH1162XVS5 Whirlpool Microwave - Instructions

For grease filter, just slipped it in outside area. For charcoal filter, unscrewed the top of microwave and replaced existing filter, then screwed back the top.

Put new plate in and it was fixed

Stood on a step stool (microwave over stove), took off the one panel,removed old filter and put in new one

Removed 2 screws on the top of the microwave and removed top/front piece of microwave. Slid out old filter (which didn't look dirty at all) and replaced it with the new one. Replaced top/front piece and 2 screws. It took less than 5 minutes.

unscrewed the screws and put the new vent in

FOLLOWED EASY INSTRUCTIONS VIA THE WEB.Note: I am a widow...83 yrs of age. Thanks for making it easy!

My daugher used the vent grill on the microwave as a handhold while putting dishes away in the cupboard and broke it. I found the part via the Whirlpool website. When the part arrived I removed the two screws, placed the new vent grill in place and replaced the screws. Total time: About 10 minutes.

Replaced filter which came inrecord time.

slide into place under hood

You had alerted that it was imperative to unplug unit before starting to remove defective bulb. As described, there was silicon on bulb and socket and bulb broke upon my attempt to remove. Had to use needle nose pliers to get metal base of old bulb from socket, then all went well.

Removed the glass cover and replaced the bulb. Very simple.

I had no problem installing the new filter. Just used a phillips screw driver to remove the two screws holding the vent cover in place. Cleaned the dust out of the ducts and reinstalled the new filter. The screws must be held to the screw driver with your finger tips so you don't drop them in the vent cover. The most difficulty I had was in clearing the clean code from the screen. There are no instructions in the owners manual for doing this. But after several tries I got it.

I unscrewed the filter cover, replaced the charcoal filter and replace the cover. The other wire mesh filter slides right into place. You sent me the right parts for my filter replacement on my microwave. Easy install. Thanks

The repair was very simple. only had to remove two screws and replaced the broken grill.

The problem I have with changing the bulb is my microwave is an overhead one and therefore I cannot tip it on its side to easily replace the bulb. I have to drop the lid down and carefully install the new bulb from underneath.