YKHMS155LWH1 KitchenAid Microwave - Instructions

Really easy to attach new grill at the bottom first (saw that on another persons installation instructions) then used a Philips screwdriver to attach top of grille in the two places one at each end., not a problem 75 year old gal, If I can do it you can do it...

The hard part was to unusable the back door.It took me a while but I was able to do it. The res it was easier just put the new handle in place and secure it with a screw driver.

Removed old outer door skin carefully so as not to break inner door or attached glass. 3 screws removed for new door skin and 2 screws need to be removed for the door handle that was not broke. Use same screws and replace on new door skin. Most of the new door skin snaps into place and is secured with the old screws. Easy maybe 15 min. to complete. Needed to pry old door skin off with flat head screw driver carefully.

remove old vent that was held in place by clips and two screws re-installed. Only problem is that should have ordered new clips was not aware that they did not come with the new vent

Open door remove the 3 screws Gently prior door apart. the outer metal piece with glass comes off easily, unscreew door handle. alignn new3 handle an use the same screew ro attach door handle. Replace outer metal piece the replace 3 screws One tool needed a phillips head

Twas really easy considering that all I had to do was place the plate back in the microwave. Easy Peasey

Tray arrived in a short period of time and was a perfect match.

removed perimeter screws from the bottom side and the lower cover is hinged at the wall side. Motor is visible and easily removed with two screws. Take of the old one, install the new one, and reverse the procedure to put the bottom cover back in place. Will nee helper to hold one side of the bottom until couple of screws can be put in on the other side.

Not so sure this would qualify as "instructions", but I only needed a screwdriver because the "D" rings of the old vent filters broke off and I had to pry to old ones out. Keep in mind, I am mechanically disadvantaged and can barely change an A/C filter ... that being said, all I did for this order was input my Model number and PartSelect found the correct replacement part. I receive the parts super quick (faster than the other 2 purchases I did that day). The only bummer was the packaging ... super huge box for small tiny parts. Otherwise, I now know where to go for replacement parts. This project should be a "no-brainer" for most DYI's, so getting the right parts with just a model number was lifesaving for me :0)

Remove old filter & insert replacement filters

Remove the screws holding the bottom vent plate to the upper unit, using a Phillips head screwdriver. Loosen a front screw last, but don't remove it. While supporting the plate in one hand, unscrew the final screw with the other. Lower the front of the bottom plate - tabs in the rear will prevent the plate from falling out. Bend the outer tabs holding the old filters in place, to allow them to be slid out. Insert the new filters & bend the tabs back into locking position. Raise the bottom plate and finger tighten a front screw. Replace and tighten all screws. This is also a simple way to remove/clean/replace the mesh filters. I've pulled the D-rings off trying to slide them out from below.