YKHMS147HBL2 KitchenAid Microwave - Instructions

Remove the screws holding the bottom vent plate to the upper unit, using a Phillips head screwdriver. Loosen a front screw last, but don't remove it. While supporting the plate in one hand, unscrew the final screw with the other. Lower the front of the bottom plate - tabs in the rear will prevent the plate from falling out. Bend the outer tabs holding the old filters in place, to allow them to be slid out. Insert the new filters & bend the tabs back into locking position. Raise the bottom plate and finger tighten a front screw. Replace and tighten all screws. This is also a simple way to remove/clean/replace the mesh filters. I've pulled the D-rings off trying to slide them out from below.

Very easy - 5 minutes and two screws. Just wish the fixings were more robust !

Installation was very easy and only took about two minutes. I am extremely pleased.

I just opened the box and set it in. Took all of two minutes.

Easy, perfect

Took the replacement plate out of the box and put it in the microwave in seconds. I never realized how much of a difference having the correct microwave plate would make. It's great to have it back.

My husband just installed the mounting plate on the wall and the microwave was placed in position and mounted in less than 5 minutes.

Problem was easily diagnosed using the internet as a resource, problem was a bad stirrer motor. Hardest part of the repair was the removal of the microwave. Once off the wall, you remove the outer cover and a molded plastic casing directly underneath the outer cover at the top of hte microwave to expose the stirrer motor. Removed two screws and two wires and the old motor is out. Did exactly the opposite to install the new motor. The kit I recvd included among other things the motor, a new inside cover, plastic rivets and even silicone to seal the inside cover. I am sure I saved a couple hundred dollars by doing myself.

What was amazing is that the part arrived the day after I ordered it, it was a perfect fit. We simply unscrewed the old door and put the new on on. Had a little trouble making it fit, but we used a little more pressure and it popped right on, we screwed it in place. Thank you for your fast delivery

Followed the instruction booklet that came with the microwave. Very easy.

My 17 yr old followed the directions and replaced the front a panel and handle in less than 25 minutes. He said it was easy and the directions were good.

This rental unit was missing the vent grille for the mounted microwave. It was super simple to install and makes the microwave look like new.

Unscrewed the lens cover anbd inserted the new bulb. Put the cover back on and there was light!

Some difficulty getting screw loosened, once that was done replaced burned out bulb.

Looked at the original instruction manual to see how it was installed, removed the two Phillips screws, fitted the grille into position until correct, then replaced the two screws.