YKBMC140HS04 KitchenAid Microwave Oven Combo - Instructions

Ordered a new one, put it in place in less than one minute.

The replacement turntable we received was an exact duplicate of the original. It was as easy as rinsing the new turntable, taking the old turntable out and putting the new one in.

Part arrived in timely manner and placed it in microwave oven.

Set the new one inside the microwave

Used the instructions I wrote up the last time. Printed them off, and still works like a charm.

This makes third time the spring has broken - last two times it has been the right side spring. Not the best designed microwave door. But at least with PartSelect having the part, and with PartSelect keeping my original instructions on the website, the repair is easy.

I followed the instructions that were posted for a do-it-yourself on the part. The instructions were spot on. One addition that I have to the online instructions is that I have a wall mounted microwave and had to remove the trim before starting the instructions. Additional instructions for wall mount are:

1. Remove one screw each side from inside the door to loosen the vertical trim.

2. Remove the vertical trim on each side.

3. Remove the 2 screws holding the bottom trim and remove the trim.

4, Follow the remaining instructions

Just put it in

Fool proof.

I took the new tray out of the box and placed it in the microwave oven.. No tools needed.

Found a way to remove screw. Proceeded to insert new spring and tried to assemble but had same problem to put screw back in. No normal tool was able to fit in and could not remove vent. Finally able to engage screw and finished reassembly.

I put the tray in the microwave???? Pretty easy.

no repair needed - ordered part, came within 3 days - very satisfied

found the part no. and ordered it. it was delivered fast and efficient.
tracking was also helpful.
thanks

Replaced the glass tray

Removed the small metal panel covering the main power terminal in back of the electric range. Removed the nuts holding the red, white and black electrical wires from the range using the appropriate socket (there will be two nuts on each bolt end). Removed the two screws holding the main power terminal block with appropriate screw driver. Connect the new main power terminal block to the range using the two screws. Reconnect the red, black and white electrical wires coming from the range using one nut for each wire. IMPORTANT: do no over tighten the nuts because the bolts could snap. Reconnect the pigtail and secure the small metal panel covering the main power panel.