WWEF3005KWB Westinghouse Range - Instructions

The parts came quickly. I removed old drip pans and snapped the new ones into place. A child could do this. Now my cooktop looks new and I am not ashamed for anyone to see it.

repaired in 5 minutes with my nut driver. So, so, so easy to make this repair. And never even attempted to call an electrician. Since long before I became an official widow, I say...who needs a man...

Unscrewed the two screws which held element in place...pulled straight out...gently pulled connector terminals off....replaced with new element connecting element terminals ...sliding element back into place (make sure terminal connection is straight (ie NOT BENT) when pushing element back into original position)and screwing screws back in...DONE!!! EASY PEASY!!!

removed the screw at the mount on each side of element .pulled old element straight out untill wire connector was out at the back of oven ..unplugged wire connector from each end of old element ..plugged wire connectors back into new element .pushed element plugs back into back of oven and installed each screw that holds element into place.. real simple

The video was a great help. I could have replaced the switch without watching it, but it gave me confidence that I was doing it right. Everything went just like he said it would. Burner seems to work better now and no more scary noises.

Replaced the oven probe because a no heat problem. also had to replace the oven control. That was a bit expensive but still saved me hundreds not calling a serviceman. By the way, it works like new.....

aftering watching your repair video the repair went very well we took the oven door off to make access easier. the worst part of the repair was getting the door back on.

Undo the two nut screws pulled out the element and replaced it with the new one.

Followed instructions on YouTube and Frgidaire website. It looked easy; was easier than it looked -)

Removed the oven door, the trim was already cleaned and ready for new glass. Once the new part arrived, I removed it from the shipping container, placed it in the bottom groove of the trim kit and tightened the screws. Then placed the top trim and handle assembly, in place and tightened the screws. Then placed the oven door back on stove.

Removed old element by taking out two screws at bottom rear of oven. Pulled element and wires forward from two holes and unclipped from wires. Clipped new element to wires and pushed the wires back into the holes. Then replaced the two screws. Needed flashlight so that 60+ eyes could see the screws and holes in the oven. A quick and inexpensive repair. Element was delivered very quickly.

took the two nuts off the back wall of the stove and disconnected the push on terminals. ordered by model number. replaced and reinstalled the two nuts in stove. simple as possible

replaced oven door glass

Unplugged stove. Quickly unscrewed back panel (4 screws). Popped the wires off one at a time attaching them to the new switch. Pulled the knob off the front, unscrewed screws, and put new switch in repeating previous steps in reverse. Put the panel back on, plugged it up, and pushed it back into place. Done.

It was just a matter of loosing 2 screws on baking element & pulling 2 wires off & putting back on. On the Burner I had to take 6 to 8 screws off back 4 wires off & 2 screws on fron of switch. Very Easy!