WTW4750YQ1 Whirlpool Washer - Instructions

Remove softener dispenser. It is hard to do, but it does pop off. Reach down inside and remove the cover. The cover has a handle. Clean the rubber gasket. The bolt holding the agitator can be removed with a socket. You will need a 12" extension. Hold one the fins on the bottom of the agitator and remove the bolt. Remove the agitator. I would recommend ordering an new rubber washer and bolt. I did not, I removed the washer from the old agitator. Install the rubber washer and place the new agitator in the washer, tighten the bolt. Use some petroleum jelly to lube the rubber washer on the cover. Install the cover. Snaps in place. Install softener dispenser. Snaps in place. Test.

Age and condition of the washer were unknown. I had no agitator grease available. I went for just the replacement of the Agitator Directional Cogs. I reviewed the video for replacing the whole kit. Removed fabric softener dispenser and the seal below. The seal needed to be cleaned. Removed the 7/16" bolt with a socket and extra long extension. Removed the agitator. Pulled off upper agitator. The part that holds the cogs is in about the center of the upper agitator. It also needed to be cleaned. One original cog was broken the other were past needing to be replaced. Replaced the cogs and the retainer. There was some effort with getting the upper agitator down far enough to re-install the bolt. That was just a slight alignment issue. The other parts were put back in place.

Super easy. Pulled off the top Fabric Softener Liquid Dispenser cap. Removed the seal. Loosened and removed the bolt (You'll need a socket extension for that). Removed the gear assembly workings and the top agitator. Removed the lower main agitator. Replaced with the new one and put everything back the way it came off. I must also note that I ordered the part from Part Select.com on Monday, and received it the very next day at noon.. Without using "next-day" shipping. How is that possible??? Part Select.com is the best!!!