Quick Question!

Have you ever purchased from PartSelect.com before?

Models > WTF330HS1 > Parts

WTF330HS1 Westinghouse Washer - Parts

All parts for the Westinghouse Washer WTF330HS1

Below is a list of all parts for the Westinghouse Washer WTF330HS1. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the WTF330HS1
1-14 of 109
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$8.86

Door Strike

The door strike on your washing machine allows your washer door to lock properly, and operate efficiently. If you notice that your washer door will not open or close, leaks, or the...

$45.37

Shock Absorber Kit

This shock absorber kit is an authentic OEM part that is sourced directly from the manufacturer. The kit includes two dual-stage shock absorbers, one spare shock mounting pin, and four locking nuts. These shock absorbers keep your front-load washer from shaking vigorously by absorbing and reducing vibrations from the wash and spin cycles of your appliance. This kit comes with two shock absorbers because it is recommended to replace both at the same time, as they wear at the same rate. To access your washer shock absorbers, simply remove the lower access panel after disconnecting the power to the appliance.

$76.22

Door Lock and Switch Assembly

This door lock and switch assembly is manufactured to lock the door on your front load washer to prevent it from opening while it is running. You may need to replace the door lock ...

$5.42

Screw-In Plastic Leveling Leg

Sold individually.

$31.31

Single Spring with Insulators

$103.99

Drain Pump - 60Hz 120V

This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time.

$6.55

SCREW

Sold individually.

$6.23

SCREW

$15.49

Drive Belt - 6 ribs

$43.60

Drain Hose

This drain hose, used in washing machines, delivers water from the drain pump to the house drain. The hose is 7 1/2 feet (90 inches) long. If your hose is leaking, it is best to replace it with a new one. To repair it, first access the back of the washer and remove the clamp holding the hose. Switch the clamp onto the new hose before placing it back into the fitting. Refer to the manual provided by the manufacturer for further instructions and guidance. Remember to unplug the appliance from the power source before beginning installation.

$51.29

Tub-To-Pump Hose

$77.93

Bellow with Clamp

Also known as the door boot seal. This part is used to keep the clothes inside the tub during the wash cycle. The folds in the bellow allow the tub to move separately from the door during the spin cycle.

$6.54

Pump Filter

$26.29

Control Rotary Knob

Sold Individually. This knob accepts a D-shaped shaft.

All Parts for the WTF330HS1
1-14 of 109