WRS26MF5AQ1 Westinghouse Refrigerator - Instructions

Our parts arrived very quickly and fit perfectly!

removed meat drawer ,,,titled on it;s side , used philip screw drivingto lossen screw ,,removed worn rail and replaced it with new one in less then a minute,,, very easy and cool ,,,

The repairs were easy. Parts came quickly after they were ordered. They easily fit into the slot for the door bins.

Received the parts promptly and did the repair just as the video showed. All went well and had the repair completed in 10 minutes. For me that was remarkable because I have two left hands! Would highly recommend partselect.com

pulled out freezer, went to floor,reached in next to compressor pulled off clip just like on the video.Pulled off old capacitator took off wire leads.Installed new one. Freezer runs great.Loaded it up with beef pork and venison. No problems.

Called repair person, 80.00 to come look at it. Deceided to see if I could find part on my own. Surfed the net found this website, ordered the part for 5.00, total 13.00 including shipping. waited a few days, received part in mail, lifted refrigerator door off hinge, inserted the part. Works like new. 80.00 plus repair, cost me 13.00. Amazing

great less than 5 minutes

Everything went according to plans and as expected. It could not have gone any easier. Customer service was outstanding! I will certainly use your service again.

First off make sure you have a good quality Phillips screw driver. When the blade is worn out you can disassemble the ice maker with out removing the front. But to reassemble the front cover must be removed. Do yourself a favor and buy the drum and nut also. I am a mechanic by trade so the tools and repair was really easy. Be careful of the ice crusher BLADES they are very sharp. If your not mechanically inclined take pictures before disassembly, that will help you greatly. Hope this helps someone. Thanks Rory

Used a nut driver to remove the small panal from the back of the refrigerator. Removed the two screws holding the valve in place. Unscrewed the water lines from the old valve and cut the ends off of them. Push the water lines back into the new valve. Unpluged the wiring from the old valve and installed them in the new valve. reinstalled the new valve and put the cover back on. Tested system for proper operation.

Pushed the bins in place,very easy.

I looked up the model number here& found the parts list. They were very detailed, making identification of the proper part easy. I then watched the repair video which showed just how easy this repair was to complete. Once the part arrived, I removed the hinge cover screw, removed the two hinge bolts and lifted the door off the bottom hinge. It took the most amount of time to remove the broken hinge bearing. The new one popped right into place. I reversed the process and was quickly finished.

This was a simple fix: 1. Take out water drip pan in bottom of ice maker. 2. Take out the three screws. 3. Pull cover upwards, no need to take out cable, have somone hold it while continuing work. 4. Take out three remaining screws from ice/water dispenser. Pull forward to show base of ice lever. 5. Take out screws that hold the little steel plates where lever shaft sits in place (2). 6. Pull out broken lever and replace with new one. 6. Put all poeces back in reverse order.

Put in the new one!

Crusher housing had broken so I ordered the part and replaced it. I have since put it back together twice. When I first installed it it crushed the ice no problem. From that point on it seems to lock up and won't crush the ice, cube ice works but the blades seems to hang up after the first use. I can turn the cog by hand but I have to turn it backwards a few times before it turns freely, however it still won't crush the ice. I took it apart and put it back together again. Same thing happened after the first time I tried it. Can you help me. The old crusher broke into. Could something else be locking up?Thanks for the help