Models > WM1815CS

WM1815CS LG Washer - Overview

Get Parts and Repair Help for WM1815CS

If you know the washer repair part you need, you can browse the list of all parts on the WM1815CS, or you can search by name or part description. You can also find your part by where it is located on the WM1815CS by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$49.29

Drain Pump and Motor Assembly

This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time. Note: Pump casing is not included.

$15.41

Water Inlet Valve - Hot

$39.37

Inlet Valve Assembly

This valve is used for cold water, bleach dispenser and prewash cycles. It has a standard hose fitting inlet with 2 outlets facing 45 degrees to the right and one outlet facing 45...

$1.96

Locking Pin

The locking pin is used to hold the shock absorber on the washer. There is a pin used at the bottom and top of the shock absorber. Sold individually.

$12.91

Parts Assembly

$8.18

Gasket

$15.41

Bearing,Ball

$20.11

Bearing,Ball

$81.34

Spider

$6.34

Pump Casing

This part connects to the drain pump and motor.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Washing maching wouldn't drain

  • Customer: Jorge from Apple Valley CA
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers
  • 131 of 173 people found this instruction helpful
Removed the top of the washer by removing the 4 back screws and 2 small brackets. Then I removed the front panel, this was actually the hardest part, 2 screws and 8 tabs that you pop out carefully from the top of the panel. I only disconnected the power button and was able to rest the panel on top of the washer. The rest of the washer came apart quickly just... read more

Worn, discolored gasket

  • Customer: Thomas from Chicago IL
  • Difficulty: Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 13 of 17 people found this instruction helpful
Removed old gasket fairly easily after removing wire and spring retainers on front and back surface. New gasket went into place relatively easily, but re-installing rear retainer was extremely difficult without special tools. Improvised a spring stretcher using steel wire looped through the eyelets in the ends of the retainer and back on itself to get levera... read more

Hot water was dripping onto sensor and caused it to stop working.

  • Customer: Lisa from Fayetteville AR
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 4 of 11 people found this instruction helpful
Took out old sensor and put in new one. read more