WER111ES0 Westinghouse Dryer - Instructions

Installed just like the video described and it went quite well. The part arrived in a short amount of time and the belt was exactly what I needed.Thank you I will visit your web site again. A very satisfied customer. :) Veronica G.

Had the macnine apart before ordering the Bearing Assembly. Reading other comments convinced me to order the Bearing Assembly. Parts were shipped very quickly after ordering and following the instructions on the web site things went back together easily.

I matched the "D" on the shaft with the part on the knob, pushed them together, and --- TAH-DAH! Done! 15 seconds tops!

followed the video instructions....easy as pie. Glad i bought the belt too....the belt on my dryer was very worn. Changed the bearing with the kit. Very easy to do. The whole job was done in an hour and a half....back together and running without the squeak. Glad i repaired instead of buying a new dryer. Next time i have a problem with an appliance, i will be checking PartSelect first.

The main drum bearing was bad and vibrated the heater coil causing the coil to break, real easy fix, take off top cover of dryer, take off front panels and door assembly, lift up drum and pull forward, replace parts =)

Pushed new knob into place. This was the cheapest, quickest, easiest repair job ever.

Replaced rear bearing on back of dryer. Repair cost $20.00 an a little time. Much better then buying a new dryer. It was easy to repair the video instructions were great. I would do it again it needed.

Your tutorial video of how to change out the heating element was so helpful, it gave me the confidence to tackle it on my own. It was so detailed, there was no worries of not knowing what to do. Everything was exactly as the video showed, and was very easy to replace this heating element. My wife was thrilled we saved money on doing it ourselves, and grateful to have the dryer working with 3 kids and a husband who works in concrete! Thank You to the Parts Select team for putting such a helpful site for people to utilize!

Found instructions on "UTube"some of the screws were in a different position but you can see them. While you have the dryer apart it's a great time to clean it and also as long as you've gone this far replace the belt,it's probably time.

The new latch easily snapped it into place.

My order confirmation email had a "how to" video for installing the parts I ordered. I just watched the video, and the installation was ridiculously easy! We've put up with the obnoxious screeching noise for probably about two years, and with about $40 in parts and less than an hour of work time, we have practically a new dryer!!

took front panel off, removed access panel in rear to disconnect the belt from motor. removed top panel (this is a stack unit) take plastic rivets loose from lint trap, remove lint trap tube, pull drum out after slightly pulling up to dislodge drum from bearing cradle, Remove bracket and bearing from back of unit, clean parts of old grease (be carefull not to loose small ball bearing on back) Reassemble parts using moderate amount of new grease, put parts back together in reverse order.

The repair was easy. Skill level one task that anyone can perform.

I just put the new knob on. Took 2 seconds. Works great.

Unplugged dryer, Removed top of dryer, Removed electrical connection to thermal limiter, tested thermal limiter with meter and found that it was bad,removed defective limiter, ordered part, waited for part (1day), put new thermal limiter in dryer. reattached connections, put top of dryer back on, plugged in dryer, attempted dryer start up and it worked. Very easy because of the information I got on this site. Thank you