WDF530PAYM4 Whirlpool Dishwasher - Instructions

Empty dishwasher remove bottom basket. Disconnect electricity then turn off water. Remove top screws from counter. Slide unit out and gently tip forward. Remove the two wires from connectors on element. Unscrew plastic nuts from element save if reusable. Gently tilt unit back to normal position. Remove old element and install new one and attach to stainless spacers to hold element in place. Tip unit forward. Reinstall plastic nuts. Plug wires back into new element connectors. Tilt back into normal position. Turn water back on check for any leaks and repair if necessary. Turn electricity back on and then slide unit back into original position and replace under counter screws. Test out by running quick cycle wash. It should function normally. During drying cycle open door to be sure it is hot inside. If hot then it is repaired. Let it finish cycle and replace basket. Do not touch hot element as it will burn you.

After finding out how to replace it (on YouTube)the repair went smoother than anticipated. the difficulty was disconnecting/connecting the electrical(BX to electric hook-up to dishwasher) due to the proximity of where it was located(~1" from the floor). Other than that, the unit now works as good as the 1st day when it was bought(~6yrs ago)

Using a Torx screwdriver, I removed the fasteners holding the control panel/latch section of the door on the dishwasher. I tested the high limit thermostat with a multimeter. Just two terminals, one being power in, the other power out. The part had what I have heard call a "high resistance open". In other words, the power was not getting from "A" to "B". Power in - not out. After cutting power to the unit, I removed the part (just pull it out of the retaining clip and pull the terminals from the part). After receiving the part...by the way, really fast delivery...I reconnected the part (it doesn't matter which wire goes where), pushed the part back into the retaining clip, replaced and fastened the control panel, then restored power to the unit. Runs like new.

Shut off water,power. disconnect water line,electric,drain.Pulled dishwasher out,laid dishwasher on it's back.Unplugged electric on pump,twisted pump out.Installed new pump and reinstalled dishwasher.

Perfict fit fast service will order from here again

My main fear was finding the part and not knowing my dishwasher model without looking it up in the owner's manual. Imagine my joy to find the part color-coded on the website and extremely easy to find!!!

Ordered Rinse Aid Cap and received the next day. Placed in the dishwasher Rinse Aid Cap position and locked in. A perfect fit.

put new one in

cap was replaced