TUD3000Y1 Whirlpool Dishwasher - Instructions
Sections
Manuals
Parts
Questions & Answers
Symptoms
Videos
Instructions
All Instructions for the TUD3000Y1
changing a damaged door panel insert
I needed to cut 1/4inch off the panel and unscrew the side piece which held it in place.... insert the new piece and put back the 3 screws. Done!
Parts Used:
Constance from Sonoma, CA
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
1 of 2 people
found this instruction helpful.
Thank you for voting!
Water inlet leaking
Removed and replaced leaking water inlet valve, 10 minutes and saved me a hundred in plumber fees.
Parts Used:
Michael from Golden Valley, MN
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver, Pliers, Screw drivers
1 of 2 people
found this instruction helpful.
Thank you for voting!
water leaking from door
The whole job took less than 5 minutes...no tools were needed The diagnosis was right on the money
Parts Used:
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
1 of 2 people
found this instruction helpful.
Thank you for voting!
Water leaking from front door of dishwasher
Took less than 5 minutes. Pried edge of old door seal out with a flathead screwdriver, then slowly pulled out old seal. Thoroughly cleaned area for new seal with rubbing alcohol, inserted new seal and trimmed the end to fit just right. Presto, no leaks whatsoever!
Parts Used:
Gregory from North Port, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
1 of 3 people
found this instruction helpful.
Thank you for voting!
Small leak in bottom right corner of dishwaher
Took off bottom plate (2 screws) and ran unit to ensure where leak is from....it appears to be the door seal. Pulled out old seal with fingers and replaced door seal, ensuring its properly "fitted"..ran unit, no leaks, put bottom plate back on
Parts Used:
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
1 of 3 people
found this instruction helpful.
Thank you for voting!
Cap did not stay in the hole any longer.....was melted
Just screwed the new cap in. This PartSelect was AWESOME. So easy. Lighting fast shipping !!!!
Parts Used:
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
2 of 6 people
found this instruction helpful.
Thank you for voting!
door seal leaked steam
It was a very simple repair. I removed the old door seal out of the track and installed the new seal.
Parts Used:
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
1 of 3 people
found this instruction helpful.
Thank you for voting!
door leaked
removed old seal, placed new seal in place. Used my fingers to push it in place. It didn't work as it still leaks. I've put vaseline on the seal and door and it helps but still leaks. The dishwasher doesn't overfill, so I still have the problem, just not as bad.
Parts Used:
Kathy from Chapel Hill, TN
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
2 of 6 people
found this instruction helpful.
Thank you for voting!
slow leak at motor/pump interface
Got parts breakdown online, took pump assy apart, ordered new parts, replaced bad parts, put pump assy and dishwasher back together, piece of cake, no problems.
Parts Used:
Donald from Webster Groves, MO
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers, Socket set
1 of 3 people
found this instruction helpful.
Thank you for voting!
Screws on the door of the dishwasher were very loose.
Went to PartsSelect. Put in Dishwasher model number. Chose the screws for that model number. Ordered the screws. Can't get any easier than that!
Parts Used:
Kathryn from Carol Stream, IL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
1 of 3 people
found this instruction helpful.
Thank you for voting!
pump seal and impeller
had to replace the insides of a leaky pump
Parts Used:
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Screw drivers, Wrench set
1 of 3 people
found this instruction helpful.
Thank you for voting!
seals were leaking,dry rotted from setting five years without using.
I Disconected The 3' hose Behind Impellor.Unscrew Cap Holding Impellor In. Pull It Out, Replce With New One.Put It Back Together In Reverse
Parts Used:
Total Repair Time:
1- 2 hours
Tools:
Pliers, Screw drivers, Socket set
2 of 7 people
found this instruction helpful.
Thank you for voting!
Front door panel was missing
I removed the cardboard insert, put the new front panel on and replaced the tabs. That was it!
Parts Used:
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
0 of 1 people
found this instruction helpful.
Thank you for voting!
water was leaking ou the door
pulled the old door seal off and pushed the new seal into place and it works great! THANK YOU!
Parts Used:
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
1 of 4 people
found this instruction helpful.
Thank you for voting!
water leaked through door gasket.
Lowered door and put a weight on it to keep it open. with screwdriver pried out the old gasket. It was simple. looked at the end of the replacement gasket and inserted it into the track with the small hole down. Job Complete. about three minutes total time.
Parts Used:
Charles F. from Burnet, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
0 of 1 people
found this instruction helpful.
Thank you for voting!
All Instructions for the TUD3000Y1