TDG336RBW2 Tappan Dryer - Instructions

Flame Sensor didn't fix it but, it was easy to replace. Unplug electric. Lift up the top and remove wires from switch and light switch. Remove screws that hold on the front and remove front panel by lifting up and out. Sensor is on the left side of the burner, held on with just one screw. EASY!

THE PROBLEM: Rust marks in the shape of a V started appearing on my clothes. I finally realized that there was gap at the bottom between the drum and the outer frame that was caused by the upper drum support having deteriorated... Clothing would slip into the gap into the area where the metal of the spinning drum was exposed - then spin upward leaving a small rust mark... INSTALLATION: The video of installing this product was spot-on! I removed the old glide and residual glue (the glue was the hardest part), then put the new glide on. After the glue dried enough to hold the felt in place, I put it all back together. So far, no more rust marks on my clothes!

lifted up the top after releasing 2 catches with the putty knife, removing front panel, held in place with 2 screws. Scrape off top felt strip with the worn teflon tabs. Wire brush off old glue. Apply glue provided.(thin coating). install new felt strip. let the glue dry for a few minutes, reinstall, and you are done.

Raised the lid, removed 2 little screws,slipped the front panel off, disconnected the safety switch, vacuumed everything, slipped on the drive belt and reversed my way out. It was way more easy than filling a grease gun!

Remove drum, replace belt, return drum

I followed the vidio from yor web site it was great without it i would still be trying to get done.

I got my order THE DAY AFTER I ORDERED IT!!!! I didn't expect that. If you can use a screwdriver you can install it. I would use this company again for anything I needed like this. Great service!!!!!

I removed two phillips head screws, lifted out the old screen and frame, dropped the new frame and screen in place and replaced the two screws. Total time to repair was less than 90 seconds.

Took the coils off and put the new one on thats all

took front off machine removing screws. Removed old felt and cleaned old glue off making sure area was clean. applied new glue and then new felt drum glide. put fish sringer around complete drum pulling tight clamping with vise grips till dry. then put front back on machine.

Installed just like the video described and it went quite well. The part arrived in a short amount of time and the belt was exactly what I needed.Thank you I will visit your web site again. A very satisfied customer. :) Veronica G.

Had the macnine apart before ordering the Bearing Assembly. Reading other comments convinced me to order the Bearing Assembly. Parts were shipped very quickly after ordering and following the instructions on the web site things went back together easily.

followed the video instructions....easy as pie. Glad i bought the belt too....the belt on my dryer was very worn. Changed the bearing with the kit. Very easy to do. The whole job was done in an hour and a half....back together and running without the squeak. Glad i repaired instead of buying a new dryer. Next time i have a problem with an appliance, i will be checking PartSelect first.

I watched the videos provided on this website and followed the instructions in the order confirmation e-mail. These were both very helpful

Replaced rear bearing on back of dryer. Repair cost $20.00 an a little time. Much better then buying a new dryer. It was easy to repair the video instructions were great. I would do it again it needed.