TDB210RFB2 Tappan Dishwasher - Instructions

I think the videos on the site are awesome. Made both repairs after watching them. They explain the repairs in a simple to follow way.

Removed the old rollers with with screw driver. Used the original screws and washers, and reinstalled the new rollers. Had been having trouble with top dish rack metal slides popping out of the old rollers. I not that the replacement rollers are slightly larger and have slightly deeper groves for the slides. Have not had the new rollers installed long enough to see if they remedied the problem. Will know in a few weeks time. So far, so good.

The spray arm simply clips to a base in the center of the dishwasher tub. The repair takes 30 seconds - the lower rack slides out, twist the base of the old spray arm to lift it off, and snap the new one on.

ordered new gasket and watched utube video

We put the new gasket on the inside of the door at the bottom in the door. It just sides into the bottom of the door. We watch the youtube and it was really easy to do.

Trim of 1/16 off door gasket with scissors left rubber at end Does not rub does not leak works great. Thank you very much. I was very satified

Based on your video instructions on YouTube.Took off door cover. Put old gasket out. Installed the new one. Put door cover back .

Watched installation video and followed directions. All went smoothly.

I turned off the power and the water then I pulled it out into the floor I used a pair of pliers to remove the hoses and disconnected the wires from the pump then I just reversed my steps i will add that the pump on mine was located low to the floor and it was a bit difficult to get the new pump on until I use a small pan to sit one side of it on to raise it up off the floor and then it was no problem getting the pump on . I’m 66 year old female and if I can do it so can you .Good Luck to all you self repair folks.

This dishwasher is pretty old and I live in a rental. When I moved in, the dishwasher leaked every time and it would had been nearly impossible to get the landlord to do any work. I read other repair stories on partselect and figured out it was the spray arm assembly. At some point the arm got detached and laid on top of the heater coil. Once it was melted and the water holes were distorted, the water shot at the door in some way to leak out the front. I replaced the part by just pushing the center part until it clicked on the bottom---- no tools were needed! The dishwasher works like a champ now. The dishes get clean the first time and no leaks on the floor. I read from other comments that the part was blue and it didn't match the original color. That wasn't as important as having a functional dishwasher. The delivery was delayed because of the health crisis, but once the warehouse sent an email that the part was shipped, I received it as was promised. All in all, I was pleased with the service and part. If there is another situation in the future, I would definitely consider using partselect again. Thank you

took old one off by hand, snaped the new one in place by hand

Just pushed it onto the rod that held the old one

I replaced the old cap with the one I ordered from this site

1. Engage B.R.A.I.N. :
B: Break open the Box. You know you'll never get it back in
R: Read Instructions: It's not more packing material.
A: Assemble New One: Put it together just like the old one
I: Ignore Instruction: Seriously, sharp edges will cut me?
N Never listen to the wife Or at least pretend to be listening

Easy just snapped on works going again like new