Models > SGR351FS0

SGR351FS0 Westinghouse Dryer - Overview

Get Parts and Repair Help for SGR351FS0

If you know the dryer repair part you need, you can browse the list of all parts on the SGR351FS0, or you can search by name or part description. You can also find your part by where it is located on the SGR351FS0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for SGR351FS0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$21.93

Rear Drum Bearing Kit

This kit includes one bearing, one ball shaft, one ball bearing, one ball bearing retainer, a small tube of high temperature lubricant and installation screws.

$10.20

Drum Belt

This 87-3/4" long dryer drum belt goes around the dryer drum and the pulley to rotate the drum once motor is activated.

$12.08

Selector Knob

This knob can be used with a washer or dryer and takes a D-shaped shaft.

$20.00

Drum Glide

Sold individually. 2 are required.

$3.17

Drum Support Bearing

$16.04

Lower Front Felt Seal with Adhesive

$24.23

Door Catch

$26.48

'M' Series Ignition Coil Kit

This ignition coil kit contains two coils. One is a two wire secondary coil, while the other is a three wire booster coil. Both should be used together in your gas clothes dryer.

$14.36

Timer Knob - White with Gray Grip

This knob accepts a D-shaped shaft.

$8.29

Bearing Bracket

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Knob replacement

  • Customer: Kevin from Donalsonville GA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 364 of 367 people found this instruction helpful
Just slipped them on and ready to go. Ordered them on thur and got em on Tues. read more

Loud Squeaking

  • Customer: Frank from Boyertown PA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 226 of 234 people found this instruction helpful
1. Unplug dryer from outlet
2. Using Lg. flat screwdriver, pry under the front edge of the top and release two spring tabs
3. Lift up top and tilt back out of your way
4. Unscrew two phillips scews on inside of front panel
5. Lift up and out the front panel. Two spring clips at bottom.
6. Rlease tension on drum belt at the motor. Acc... read more

Motor would hum but not turn on when start knob was turned.

  • Customer: Elvis from Miami FL
  • Difficulty: Easy
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Screw drivers, Socket set
  • 124 of 141 people found this instruction helpful
The motor bearings had stiffened up – classic planned obsolescence.

I could tell the motor was bad, because when I tried to spin the drum by hand, it wouldn't turn in any direction. (Normally it can turn fairly easily.)

(Helpful hint: As you remove screws / parts, place them in a plastic baggie, and write on the baggie from whence t... read more