Models > SGR231HS1

SGR231HS1 Westinghouse Dryer - Overview

Get Parts and Repair Help for SGR231HS1

If you know the dryer repair part you need, you can browse the list of all parts on the SGR231HS1, or you can search by name or part description. You can also find your part by where it is located on the SGR231HS1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for SGR231HS1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$19.92

Rear Drum Bearing Kit

This kit includes one bearing, one ball shaft, one ball bearing, one ball bearing retainer, a small tube of high temperature lubricant and installation screws.

$8.61

Drum Belt

This 87-3/4" long dryer drum belt goes around the dryer drum and the pulley to rotate the drum once motor is activated.

$19.45

Drum Glide

Sold individually. 2 are required.

$2.77

Drum Support Bearing

$13.81

Lower Front Felt Seal with Adhesive

$23.71

Door Catch

$9.34

Timer Knob

$10.96

Lint Filter

This white dryer lint filter screen collects lint as it passes through the dryer vent.

$22.77

'M' Series Ignition Coil Kit

This ignition coil kit contains two coils. One is a two wire secondary coil, while the other is a three wire booster coil. Both should be used together in your gas clothes dryer.

$34.34

Ball Hitch

You can get this part in a kit also.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Original timer knob broke

  • Customer: Cheri from Cary NC
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 458 of 459 people found this instruction helpful
I looked in my appliance paperwork, found the model number, keyed it in, located and ordered the knob. It arrived in a few days and voila, pushed new knob on and dryer is back in great working order. Thanks! read more

Loud Squeaking

  • Customer: Frank from Boyertown PA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 245 of 253 people found this instruction helpful
1. Unplug dryer from outlet
2. Using Lg. flat screwdriver, pry under the front edge of the top and release two spring tabs
3. Lift up top and tilt back out of your way
4. Unscrew two phillips scews on inside of front panel
5. Lift up and out the front panel. Two spring clips at bottom.
6. Rlease tension on drum belt at the motor. Acc... read more

Motor would hum but not turn on when start knob was turned.

  • Customer: Elvis from Miami FL
  • Difficulty: Easy
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Screw drivers, Socket set
  • 135 of 155 people found this instruction helpful
The motor bearings had stiffened up – classic planned obsolescence.

I could tell the motor was bad, because when I tried to spin the drum by hand, it wouldn't turn in any direction. (Normally it can turn fairly easily.)

(Helpful hint: As you remove screws / parts, place them in a plastic baggie, and write on the baggie from whence t... read more