Quick Question!

Have you ever purchased from PartSelect.com before?

Models > SGQ2170KS0 > Parts

SGQ2170KS0 Westinghouse Dryer - Parts

All parts for the Westinghouse Dryer SGQ2170KS0

Below is a list of all parts for the Westinghouse Dryer SGQ2170KS0. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the SGQ2170KS0
1-14 of 109
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$28.49

Door Catch

The door catch on your dryer is an important part as it keeps your dryer door closed, in order to ensure no air or clothes can escape. This part works by holding the door strike, w...

$14.16

'M' Series Ignition Coil Kit

This kit contains two coils, one is a two-wire secondary coil and the other is a three-wire booster coil. Both coils in the ignition coil kit should be used together in the clothes dryer. Some of the symptoms that this kit could be a solution for are: If there is no heat, not enough heat, or clothes takes too long to dry. In this case, the gas valve coils can be defective and replacing this part will help. Customers rate this project as easy. Refer to the installation diagram for further instructions. For safety, unplug your dryer before repair.

$78.15

Blower Housing with Blower Wheel

***Please Note: This part is a substituted part by the manufacturer. It may appear different, but should still work with your appliance.

$27.77

Control Thermistor

This part controls the temperature of the inside of the dryer drum and prevents the dryer from overheating. This part is located in the blower housing.

$8.47

Door Strike

The door strike is attached to the door of your dryer and holds the door closed. If your dryer door is not closing, this might be due to the door strike needing to be replaced. Thi...

$22.09

Flame Sensor

This part senses the flame for heat allowing the gas valve to open. The most common issue that might arise that would indicate the flame sensor needs to be replaced is your dryer is not giving off enough heat. If your clothes are not drying at a reasonable time, this might be your first indication of an issue. You will need to remove the two screws underneath the lint cover to remove the top of the appliance. Release the door switch wiring, remove the front panel, and remove the belt off the pully. You should now be able to completely remove the drum from the dryer. This will give you access to the sensor for the repair.

$95.42

Door Handle

Handle only.

$29.66

High Temperature Adhesive

This high temperature adhesive is used for installing felt and rubber seals on dryers. The tube contains 1 ounce of product. This adhesive is made to withstand extremely hot temperatures. Before applying the adhesive, ensure that the area is completely clean from any debris and is dry. You may wish to use small clamps to hold the material in place while it dries. If the felt has come loose or broken apart, this may cause your dryer to make loud noise, indicating that new felt or rubber needs to be glued into place. Use gloves to apply glue.

$6.67

SCREW

Sold individually.

$16.16

LIMITER

$14.96

LIMITER

$38.24

Lint Filter - White

$20.24

Door Hinge

Sold individually.

$8.86

SWITCH

This switch is for a dryer door with a drum light.

All Parts for the SGQ2170KS0
1-14 of 109