S2100E6WW General Electric Washer - Instructions

I used the piler to take off the old knob then install the new one.

I went on Utube and watched a video. Explains exactly what you have to do. A real skinny pair of electrical pliers helps to get the plastic pin out. The replacement knob comes with a new pin. This repair actually does take less than 15 minutes.

I removed the clip with needle nose pliers pulled the knob off,put the new knob on and replaced the clip.

replaced the dual water inlet valve

I laid the washer on its front and removed enough screws to fold the bottom out enough to reach it. I used a wire tie to secure the belt to main pulley and slipped it on the drive. This would have been nearly impossible without the install tool as it stopped the belt from slipping off of the drive. It was simple to turn the pulley clockwise to walk the belt onto it. The whole repair took about 1/2 hour, would have been less if I had used the wire tie at the very beginning.

pushed replacement knob on shaft of dryer. machine works better than new. took less than 24 hours from time of order to time of delivery to my house.

remove top panel, replace the compression clip, then replace'd the top panel, w/pliers, remove'd then plastic clip from the timer knob, remove old knob, install new one, DONE! I've never had a place that had all parts in stock, and at my door with-in 2 days! UN-BELEIVABLE! THANKS

I removed the plastic pin, took the knob off, put the new one on, then replaced the plastic pin. EXTREMELY easy.

order part. replace

I watched the video you provided and I could't believe how simple it was. I'm 67 yrs old and I just followed the video instructions.

Took the front panel off and it looked like everything was OK with the transmission, etc. Pulled out the agitator and noticed that the coupler had stripped out splines. New coupler was a later design, but was backward compatible with the new bolt included. Spline slipped on with no problem and hold down bolt snugged down just fine. Snapped the agitator back on and was in business.

old dryer knob had lost its spring and would not turn on. simply pulled old knob off and replaced by pushing new knob onto shaft. voila! saved myself a service call.

Removed the old part with a screwdriver and replaced with the new parts. As good as new!!

Installed a new mixing value. Repair went quickly and easily. Repaired machine working great. Easy ordering and the prompt shipping impressed us Greatly!! Thank you!

at 1st, i call GE for service, but i have to wait for the next available field service engineer which is 7 to 8 days to come to my place to check on the washer. the cost is $99.00(non refundable) and then he will order the parts needed for repair another 2 to 3 days. then i decided to buy the parts myself online,and google the web on "how to fix the washer that stopped agitating" everythings in there,with video instruction. pull the agitator up and out by grabbing on to its base. inside, the knot was corroded and the o ring worn out,but really easy to remove with the 11mm socket. the coupling kit although looks different,fit perfectly. insert says its an upgrade of the old model. toss the old and replace with the new, no sweat! now it's shaking like crazy.