Models > S160-C > Instructions

S160-C Jenn-Air Range - Instructions

All Instructions for the S160-C
256 - 264 of 264
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Oven wouldn't heat to temperature
Turn the power off to the oven. Removed two screws on the back of the oven which held the element in place. Gently pulled out element and unhooked it from the clips. I then got the new element and hooked it back into the clips. I pushed it back in and replaced the two screws. Restored the power and turned on the oven. It works like new!
Parts Used:
Bake Element (16 Inch long x 19 Inch wide)
  • Debbie from Fremont, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Cleaned stove. When temperature knob was cleaned, temperature settings were wiped clean.
Received the part within 10 days and installed in less than 60 seconds.
Parts Used:
Thermostat Knob
  • Rebecca from Spartanburg, SC
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Frozen screws
Followed instructions. Two screws frozen. Unable to loosen. Forced to grind heads off and replace with new screws.
Parts Used:
Oven Door Seal
  • Jack from Lake Wells, FL
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Left Rear Burner would not work
Shut off breaker, removed the top by unscrewing the retaining screws and removing all knobs and grommets. Removed control from top panel by unscrewing, removed 5 wires and placed on new control. I then remounted the control, placed the top in its well, fastened. Replaced the retaining screws in the hold down strip and replaced grommets and knobs. Returned power to panel by turning the breaker on and tested. Used later that evening to grill 2 panini.
Parts Used:
Surface Burner Switch - 240V
  • Sharyl K from Nampa, ID
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
range installer broke a screw off & busted the plastic piece
Had to screw off old terminal block & screw on new one
Parts Used:
Main Power Terminal Block
  • Christina from West Des Moines, IA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Filter element missing screen material from age and cleaning
Lifter grill and replaced filter. It fit perfectly.
Parts Used:
Grease Filter
  • Harry from Bedford, VA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Oven not heating
Ordered oven element. Had to use liquid wrench to loosen screws holding element in place. replaced, It works. Now the top left burners don't heat up.
Parts Used:
Bake Element (16 Inch long x 19 Inch wide)
  • George from Atwoter, CA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    1- 2 hours
  • Tools:
    Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
2 broken oven door springs
I watched the youtube video that was provided by this website on my computer while doing this repair step by step. It was a snap!
Parts Used:
Door Hinge
  • Kim from Brecksville, OH
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Heat Errosion
Wife installed them, they just snap into place on the Rock Grate.
Parts Used:
Rock Grate Support
  • Fred from Temple Terrace, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the S160-C
256 - 264 of 264
Back to Top