Quick Question!

Have you ever purchased from PartSelect.com before?

Models > RVM225BL01 > Parts

RVM225BL01 Hotpoint Microwave - Parts

All parts for the Hotpoint Microwave RVM225BL01

Below is a list of all parts for the Hotpoint Microwave RVM225BL01 - Microwave Hood Combo. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the RVM225BL01
1-14 of 87
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$6.98

Light Bulb - 40W 130V

This light bulb is a 40 watt, 130-volt clear appliance light bulb that is manufactured to fit microwaves with small-base light bulb sockets. The light bulb illuminates the inside o...

$13.05

Light Socket - 250V 75W

This is a light bulb socket that is manufactured to fit a microwave appliance. The socket is meant to fit small-base light bulbs. The light bulb is not included with this part, so consider ordering the light bulb if necessary. You may need to replace this part if the existing socket is broken, cracked, or if light bulb is not turning on, and a new light bulb does not work. This is an electrical part so please be sure to disconnect power to your appliance before repair.

$21.50

Secondary Door Switch

The secondary door switch is a simple on/off mechanism that stops the microwave from operating when the door is open. The switch monitors the door latch position, and communicates ...

$19.78

Monitor Door Switch

Unplug your microwave before attempting this repair. You will need to remove the grill, which is held into place by two screws at the top of the grill (open your microwave door before doing this). Remove the grill. Remove the screw on the left holding the control panel in place. Loosen the screw behind the panel. You should now be able to lift the panel up and pull forward to detach. You will find the door switch by removing the screws to detach the switch assembly. Press on the release tab to remove the middle switch. Disconnect the wire connector to release the old switch.

$2.56

Grille Screw

$22.20

Hood Damper Assembly

$35.64

Grease Filter

$25.85

Thermostat Cut-Out

Also known as Thermostat or Humidity Sensor for Fault Code.

$69.14

High Voltage Diode

This diode has a 1/4" female connection and an eyelet.

$18.16

Vent Thermostat

The thermostat opens and closes if it gets too hot to run the vent fan.

$72.17

High-Voltage Capacitor - 2100V

$19.57

FUSE

$14.56

SOCKET-PROBE

RVM225BL 225

All Parts for the RVM225BL01
1-14 of 87