Models > RUD3000DQ1 > Instructions

RUD3000DQ1 Roper Dishwasher - Instructions

All Instructions for the RUD3000DQ1
91 - 105 of 153
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
pump seal and impeller
had to replace the insides of a leaky pump
Parts Used:
IMPELLER
  • David from Lisbon, IA
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    1- 2 hours
  • Tools:
    Screw drivers, Wrench set
1 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Water leaking from front door of dishwasher
Took less than 5 minutes. Pried edge of old door seal out with a flathead screwdriver, then slowly pulled out old seal. Thoroughly cleaned area for new seal with rubbing alcohol, inserted new seal and trimmed the end to fit just right. Presto, no leaks whatsoever!
Parts Used:
Dishwasher Door Gasket - Gray
  • Gregory from North Port, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
1 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Screws on the door of the dishwasher were very loose.
Went to PartsSelect. Put in Dishwasher model number. Chose the screws for that model number. Ordered the screws. Can't get any easier than that!
Parts Used:
Screw
  • Kathryn from Carol Stream, IL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
1 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
seals were leaking,dry rotted from setting five years without using.
I Disconected The 3' hose Behind Impellor.Unscrew Cap Holding Impellor In. Pull It Out, Replce With New One.Put It Back Together In Reverse
Parts Used:
IMPELLER
  • mike from seymour, IN
  • Difficulty Level:
    Easy
  • Total Repair Time:
    1- 2 hours
  • Tools:
    Pliers, Screw drivers, Socket set
2 of 7 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
water was leaking ou the door
pulled the old door seal off and pushed the new seal into place and it works great!
THANK YOU!
Parts Used:
Dishwasher Door Gasket - Gray
  • ROSE from ELVERSON, PA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
1 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
water leaked through door gasket.
Lowered door and put a weight on it to keep it open. with screwdriver pried out the old gasket. It was simple. looked at the end of the replacement gasket and inserted it into the track with the small hole down. Job Complete. about three minutes total time.
Parts Used:
Dishwasher Door Gasket - Gray
  • Charles F. from Burnet, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Water Seeping From Under/Around The Door
I opened the door and pulled the gasket from around the dishwasher. The gasket does not have any adhesive around it, so it pulled free almost immediately. The new gasket was pressed into place around the door and I was done. It couldn't have been any easier. I suspected it was the gasket when I saw pinched portions that did not return to the original shape and there were no visible cracks in the machine.
Parts Used:
Dishwasher Door Gasket - Gray
  • Nate from Fort Worth, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
leaking around door
1-2-3 EASIEST JOB I EVER HAD to DO AND THE WIFE IS PROUD OF ME FINALLY.

THANKS , , ,Bat from WEST SENECA (Buffalo, NY)
Parts Used:
Dishwasher Door Gasket - Gray
  • john a from west seneca, NY
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
1 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
I broke one part trying to install
no tools necessary buy instructions would have brrn helpful
Parts Used:
Pin (Lid Hinge)
  • dwight from onaka, SD
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
front leak
pulled out the old gasket, aligned and pressed in the new gasket
Parts Used:
Dishwasher Door Gasket - Gray
  • Rod from Dripping Springs, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Broken Part
I just installed the new part. There were no tools required. I bought an extra part
I ordered the part on Monday, and it arrivefor the other side in case it breaks.
d by FedEx the next day. I live in Southern California.

Great service, thanks.
Parts Used:
Upper Track End Cap
  • Gary from Palm Springs, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
3 of 10 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
My Dishwasher Started Leaking Out The Bottom Of The Impeller Assembly.
I went on line and found the partselect website and was able to identify the defective parts using the schematic drawings. I ordered the parts and in about an hour I had reassembled the dishwasher and had it running again much to the joy of my wife and children. (No more washing dishes by hand!). I also purchased the touch-up paint and tine tips and now the washer looks and runs like it did when I purchased it.
Parts Used:
Vinyl Touch-Up White Tine Tips IMPELLER Seal, Drain Cover RING
  • John from Eldersburg, MD
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    1- 2 hours
  • Tools:
    Nutdriver, Pliers, Screw drivers, Socket set
6 of 20 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
leak in dishwasher
This was an easy fix. My husband took out the old gasket and put the new one in. It fit perfectly and no more leak. The part got to us really quickly too and that was nice. No more hand washing the dishes! :)
Parts Used:
Dishwasher Door Gasket - Gray
  • Carolyn from Keithville, LA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Pliers
0 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Not cleaning like it should
Replaced old worn out parts with new ones.
Now it cleans like it should once again.
Parts Used:
Lower Spray Arm with Tower
  • Arnaud from FR SETTLEMENT, LA
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
1 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The detergent door won't open fully
Sorry, probably need a spring as the door is fine. While reading other stories about how hard the spring was to get right, I assumed the spring was part of the door assembly.
I'll be calling and returnint the part.



















i'
Parts Used:
Soap Dispenser Cover
  • Bob from Carlsbad, CA
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    Less than 15 mins
0 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the RUD3000DQ1
91 - 105 of 153
Back to Top