RT21LMXKQ01 Roper Refrigerator - Instructions

There are two tabs that hold the icemaker to the rails it sits on. I use a small screwdriver and pushed the tabs up to release the tray and slid the Ice maker out. the cover over the control motor just pops right off. Then I removed three screws from the control motor pulled it off and put the new on, replaced the screws and put the cover back on and slid the icemaker back into the rails. I shut the freezer door and within the five minutes it took me to put my tools back in the garage, it was dumping ice. Very easy to fix. You do not need to remove the screws that hold the icemaker to the tray.

removedicemaker and unscrewed 3 screws hill ding motor assembly and control module to ice maker . nstalled new part and attached it with the 3screws. reinstalled ice maker and ice making cycle began almost immediately.

Definitely watch the demo video. It described every aspect to remove old unit and install the new one. Made the install 'childs-play'!!

Removed ice maker and installed new part

Turned off the icemaker and took out the hex screw at the back of the unit that held the cable guard. The ice maker was easy to slide out after releasing guide locks on each side of the unit. Pulled the unit forward and released the electrical connection. With the unit on the cabinet, I removed the motor housing cover. Took out the 3 scews holding it in place and the old motor was out. Just reverse the steps putting the new one in. In an hour or two we heard ice dumping into the holder.

imakers first replaced the water inlet valve. that didn't fix the problem, but increased the water column to the water dispenser. replacing the icemker cured the problem! I now have $200 ice!!! your service was great! the part arrived as promised!

Removed icemaker, replaced motor and reinstalled. Very quick delivery of parts, fit perfectly.

replaced the motor control assembly and it works great

Istalled new ice maker in about twenty minutes.Very satisfied .