RCC3024RB01 Whirlpool Cooktop - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Bowl of potatoes dropped from microwave breaking glass top
Turned off electricity at service panel. Removed drawer from cabinet. Removed 2 mounting clamps from under counter. Removed knobs and grommets. Lift range from counter top. Removed 10 perimeter screws from glass mounting tabs. Removed broken glass top. Mount new glass top. Adjust position of tabs with pliers. Install 10 mounting screws. Replace range in counter top. Space above top with small sticks. Applied clear silicone to perimeter of glass at counter top. Removed spacers and seated glass to counter top. Cleaned silicone joint. Replace grommets and knobs. Replaced 2 under counter clamps. Replaced cabinet drawer. Restored power at service panel. Clean up.
Parts Used:
-
Darwin from Tomball, TX
-
Difficulty Level:Easy
-
Total Repair Time:1- 2 hours
-
Tools:Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Small Surface Burner Was not Working
Repair video was very helpful. I have removed the screws on both sides of the appliance under the surface plate, in the front. The Owen door has to be open for that. Then I have pulled the surface plate for a little space to disconnect the two connectors. Turned the surface plate over on the kitchen table, removed the 6 screws. Turned the burners assembly over and removed the small burner by disengaging the two clips. I have removed the 2 clops from the burned burner and assembled it to the new burner. I have placed the burner and engaged the 2 clips with a crownose players. I have removed one electrical connecter at a time and connected to the new burner. I have turned over the assembly over the glass plate and assembled the back cover with 6 screws. Put the surface plate on the range and connected the 2 connectors, pushed back, lined it up with the 2 screw holes in front of the range on bot sides and put the 2 screws in and Finished.
Parts Used:
-
Tevfik from Naugatuck, CT
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Beingold the glass top stuck hard
unscrew 3 screws under the control panel and pull that away from the glass top making sure the wires don't come apart from the connectors. care fully slide the glass forward and replace the burner which was the easy part. DO NOT try to test without making sure that none of the burner are touching the metal surface!!!!!!!! it will trip your breaker. But now we have a range with 4 burner after a year THANKS
Parts Used:
-
Mansukhlal Dayabhai from Moultrie, GA
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!