Models > RB17FA-2AF (7C14A)

RB17FA-2AF (7C14A) Magic Chef Refrigerator - Overview

Get Parts and Repair Help for RB17FA-2AF

If you know the refrigerator repair part you need, you can browse the list of all parts on the RB17FA-2AF, or you can search by name or part description. You can also find your part by where it is located on the RB17FA-2AF by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for RB17FA-2AF parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$30.70

Condenser Fan Motor Kit

This condenser fan motor operates in a clockwise fashion and carries carries 2W and 115V. It comes with screws, a blade mounting nut, and a cushion. This part provides forced-air ...

$2.70

Screw

Sold individually.

$2.70

Screw

This screw is sold individually.

$2.03

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

$34.01

Single Outlet Water Valve Kit

The water inlet valve is a solenoid-operated switch located at the bottom of the refrigerator. When it is energized by electrical power, water is released from the supply line thro...

$2.70

SCREW

Sold individually.

$3.96

Compression Nut

$3.56

Plastic Tubing

1/4" Plastic tubing, 8 1/2 feet long.

$59.62

Evaporator Fan Motor - Blade NOT Included

This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils.

$2.70

Inlet Hose Gasket

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Sometimes the condenser fan would start causing the refrigerator to overheat.

  • Customer: Tom from Franklin WI
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers
  • 89 of 92 people found this instruction helpful
Unplug the appliance.
Removed the screws holding the back panel.
Removed the fan blade.
removed 3 screws holding the condenser fan.
Remove the 3 metal brackets attached to the fan.
(First note which studs the brackets are attached to. Attach the 3 metal brackets to the new fan. (New screws were supplied)
Cut and strip the wire a... read more

cocktails running out of ice

  • Customer: Craig from Westminster CA
  • Difficulty: Very Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set, Wrench set, Wrench(Adjustable)
  • 49 of 54 people found this instruction helpful
filled both ice cube trays up with water and placed in the freezer.. within hours my ice oproduction was doubled! no more warm cocktails : ) read more

no water getting to ice maker

  • Customer: Kevin from Boston MA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers, Wrench(Adjustable)
  • 36 of 43 people found this instruction helpful
The ice maker had been slowly dying and one day just stopped making ice. No water was getting to the trays.

I read that this could be caused by a failure of the valve, even though the continuity test indicated that the solenoid was okay.

I ordered the part Friday afternoon. It was delivered Saturday. I did the repair in 10 minutes.
read more