RAB5232EN0 Roper Washer - Instructions

I was thrilled that the agitator parts were so easy to replace, but that didn't totally fix my problem. I looked underneath the washer and found black rubber shavings from a worn part and looked online and found that the problem was most likely the Direct Drive Motor Coupling. I watched the video and ordered the part. The coupling was actually broken. After replacing the part, the washer works great...better than it has in years. I think I will work on our dryer now.

Realized the new part was highly improved with the heavy metal insert to just screw on. Screwed it on to the existing extension on the unit and that was it! Five minutes!

Disconnect water supply hoses, water drain hose, power cord. Move washer into position to lay on it's side. Use pliers to remove hoses on direct drive. Pull direct drive away from electric motor, replace with new direct drive. reconnect washer in it's place. done.

The most difficult part was aligning the two sides of the coupling. Disassembling the motor from the transmission was a snap. The replacement coupling was of higher quality than the original. It had metal bushings in the center holes, where they interface each driveshaft. The original did not. It was plastic.

It went very easy and the part was right very easy job to do saved a lot of money thanks to you thanks a lot

The repair went very well as per the video, however the metal reinforced coupling only went onto the shaft half way. To ensure the coupling was flush with the top of the shaft I has to use a hammer and tamp the coupling onto the shafts. If you left it halfway on the shafts there was no room for the rubber spacer between the couplings. Other wise it operates very well.

My 15 year old daughter did the repair.

You guys are "Awesome" I wish I had known about your site and watched the video's first!!! When my washer started acting up, I tore it down to parade rest trying to figure out why it wasn't spinning! Then I discovered your web site searching for help. Anyhow, it identified my problem, I watched the video on the most likely cause (the Direct Drive Motor Coupling), checked it out, and discovered one of the couplings was cracked and rounded out..... Thanks to you, the washer's fixed and I can't Thank you enough! Sincerely, Terry Kuster P.S. Everyone will know about your Web site. Thanks again!

After watching the video that came with the parts, it was straight forward, very well informative.

Put washing machine on it's back giving easy access to the bottom and the impeller. Removed hoses, clamps on the pump and it slips off. Put on new pump, hoses and clamps...job was done. Stood the machine upright and reconnected the inlet hoses with new washers.

I followed the instructions from other readers(almost). I failed to move the panel assembly to a more spacious spot so doing it in cramped quarters made it unnecessarily harder. The hardest part was finding a metric socket to loosen the screw holding the ground wire.Part came well protected in shipping carton and on time.Hopefully I won't ever have to use Partselect in the future(dream on) but I highly recommend them and would use them again. jk

well ttook 2 screws out of the top unhook the wire to door pulled front back away from back and there it was easy as apple.

1. visited web site followed path for symptoms, identified part ordered 2. Dismantled Washer, removed motor, replaced coupling and re-assembled. 3 Tested outside to confirm working order before returning washer to inside location 4. Moved washer back inside.

I followed the step by step instructions on the computer stopping and starting the program as I went. Thanks Partselect

Just watched the video provided by parts select and then went to work. Excellent video. If I had been better mechanically inclined it would have been much faster. Thank You Parts Select! Also fast shipping.