I had to remove the clear plastic from the old part and install it on the new frame. I put the plastic in first and could have easily broken a pin. There should be a recommendation to put the frame in when it can bend a little and reduce the chance of breakage again. Put the clear plastic piece back in after the frame is in. That would have been much easier.
Ice Maker assembly was leaking into cube tray and fusing all cubes together.
Remove Ice maker tray and remove one screw on left side holding wire harness cover on. Remove wire harness cover, disconnect wire harness, pull out Ice Maker Assembly. Install new Ice Maker Assembly, plug in new wire harness & screw harness cover back on.
Drawer was left open when doors were shut. Broke one of the pins that holds the drawer cover in place
Removed the clear plexiglass window. Cleaned it with soap and warm water preparing it to be installed into the new Drawer Cover Frame. Re-installed the Plexiglass into the new frame and mounted cover assembly to its fixing place.
1.) Remove produce drawers above deli drawer. (2). Place right side pin of deli drawer cover into hole. Note that hole on right side has a raised lip so you need to insert this side first. (3). Sprayed PAM cooking spray on deli drawer near hole on left side. (4). Slide left side pin on deli cover into hole on left side. 5 minute job, quite easy. Use cooking spray to lubricate the pin so you don't have to force it into hole on left side and risk breaking it.
Factory installed rail was overtightened and fractured the rail. Subsequent use resulted in rail failure.
Remove drawers and internal shelf supported by rail(no tools). Remove rail (phillips). Remove roller from existing rail. Intall roller on new rail. Install new rail (phillips). Replace shelf and drawers. Note: New roller (identified as a separate part) and screws are not included with rail.