NBXR463EB0WW Hotpoint Dryer - Instructions

Remove & rplace switch

its very easy!! just pull or pry out the old handle clean surface snap in the new one! its that easy!! PS don't get to rough with the installation!!

Drum slide slots had worn so bad that i needed to replace the whole thing. I had already taken it apart before to change drum slides and knew it was a matter of time before the whole bearing was going to need to be replaced.

removed what was left of old door handle and replaced it with new handle. Snapped right in without any trouble, 30 seconds max.

just installed it

I checked out YouTube and found some really helpful videos from various appliance guys. The parts came fast and I knocked out the repairs in about an hour. Replacing the front and rear bearings was a breeze and no more squealing. Just like new

read and looked up the blown up picture of the dryer , got the correct tools and removed the two screws in the top of the dryer door , removed the top , removed the two screws on top going to the sides , then one screw in the front lower left side to allow the left side wall spread apart ,took the idler arm and belt off the motor shaft , picked up the drum with the belt and pulled it out forward. ordered the correct parts that were recomended . parts came the next day , instructions on your web page were awesome .. and it runs better then new !!!! thank you very much ! and i believe i saved a bunch of money !!

I followed the provided video precisely. Made the job quite easy. My only problem is I'm 6'2", 275 lbs. with bad knees. Can't go at it exactly as shown in the video because I can't squat down in front of the dryer without pain. Called in a neighbor of smaller stature for him to come from one side, and me from the other. Worked flawlessly. Video is excellent. I do recommend wearing gloves and/or long sleeve shirt. I cut up my arms a bit, but that could have been easily avoided.

replaced the parts that had worn out

Removed 2 Phillips heads on front panel. Removed 4 hex heads on back panel controller. Took off lid. Took 2 Phillips screws on inside by door out. Lifted door off. Discovered on front seal housing 2.5 of 4 seals gone. Replaced front seal bearing and lower felt seal.. A must...vacuum at all the dust! Replaced the green and white seals. Put all back together. My 17 year old dryer is like new again and quiet. Did this for $37. Front seal housing was fine so could have did for $20. Also thanks part select. I ordered at noon on Monday and had Tuesday at 5pm.

watched video and followed instructions. Made my wife very happy not having to buy a new dryer. Thank You, Joe

Ordered the recommended parts on-line and they showed up the next day. I followed the on-line repair video that described it all step-by-step.

There is a video for this repair that partselect.com did. I watched the video . These are perfect instructions. Total time for repair was 40 minutes and this is the first time I ever worked on a clothes dryer. Make sure you have a #2 square screwdriver before you start.

Removed the top by removing the two screws in the top of the door. Then removed the front by removing a screw on each side. To remove the bearing I had to remove the light bulb and then pull from the top. It popped right out. Installed the new bearing, inserted the slides. Although it still looked in good shape, I replaced the felt seal since I had the front open. Reinstalled the door and the top and I was done. Easy Peasy, Saved myself over $100.

Followed the online demonstration on the website when i ordered the part. The video was outstanding and easy to follow. I now have the confidence to make other minor appliance repairs.