Models > MMC5193AAB

MMC5193AAB Maytag Microwave - Overview

Get Parts and Repair Help for MMC5193AAB

If you know the microwave repair part you need, you can browse the list of all parts on the MMC5193AAB, or you can search by name or part description. You can also find your part by where it is located on the MMC5193AAB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$11.80

Black Sleeve Diode

$18.17

Light Bulb

Sold individually.

$3.37

Ceramic Fuse - 20 Amp

This ceramic microwave fuse is white in the center, while each end is made of metal. This is a twenty amp fuse.

$1.98

SPRING-BUTTON;-,HSWR,PI0

$147.91

Magnetron

$21.82

THERMOSTAT

$1.98

THERMOSTAT;NT-101,250V 1

$3.54

COVER-MGT

$36.95

ASSY GUIDE ROLLER;MS9796

$23.61

SENSOR GAS;ST-MWO,TGS880

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

microwave oven blew fuse

  • Customer: tad from tamarack MN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 12 of 18 people found this instruction helpful
First I removed upper front grill by removing two Philips head screws on top and pulling off. This exposed the Philips head screw which holds control panel in place. After removing screw I pushed up on panel and it came off to expose fuse. With needle nose pliers I removed old fuse and again with pliers held new fuse in position. With the help of a bladed s... read more

interior lamp burnt out

  • Customer: leverett from villa ridge MO
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers
  • 7 of 12 people found this instruction helpful
remove outer cover of microwave, (special recessed star bit required) change bulb, unplug and remove 1 phillips screw. read more

Died while heating lasagna

  • Customer: connie from madison NC
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 6 of 11 people found this instruction helpful
Removed 4 small star head screws from back of microwave, lifted body off, removed blown fuse and replaced with new one (found where cord enters). This model is stainless inside and out and I like it a lot. It is also sold by Daewoo and a few other manufacturers. read more