MHE13XHQ1 Roper Microwave - Instructions

Kept the screws from the old part. Simply slide the new grille in place and screw in the two holding screws!

remove one screw from light and remove bulbs replace. I found the light plate had a lot of grease on rubber type washer for the glass cover. I cleaned it as best I could. The real trick was putting the screw back in when the Microwave is in with the hood Fan and the screw must go straight up and not miss the hole. I had someone hold the plate up and the screw went in. Your instruction book shows your filters and how to clean them. They are easy to and clean. What I found best is the lights they had been in for 15 years and the new ones are so much brighter. I now have an old set of filters that can be put in the dishwasher and used as a replacement when the new ones need to be cleaned.

Went on very easy

All the electrics worked on Amana microwave EXCEPT for the cooking function. Inspected the control board and found the upper switch on the door interlock was burnt. Installed new switch in minutes and everything now works fine. Unfortunately, had to purchase expensive two switch "kit" although only one switch was kaput. PartsSelect mailing was SUPER fast. Thanks for looking, Scott

Unscrew the vent grill and took it off. Then remove the air filter and clean off the surrounding area. Then install the new air filter and vent grill. Put on the two screw and i was done. All done in less than 10 minutes.

My wife was pushing a few buttons with her knuckle (hands were full)and the microwave just turned off. Just like we had blown a breaker. First I unpluged it. Then I removed the phillips screws of the front panel, and found and removed the ceramic fuse. 3 days later I received the new fuse in the mail, and put it in. I plugged the microwave back in and it works great.

The problem I have with changing the bulb is my microwave is an overhead one and therefore I cannot tip it on its side to easily replace the bulb. I have to drop the lid down and carefully install the new bulb from underneath.

Removed the glass cover and replaced the bulb. Very simple.

I bought the stir cover replacement (package comes with 2) and two rivits (didn't fit). I pulled off the original cover and pulled out the rivits (easy peazy). The stir cover fit perfectly but the rivits were too big (and I tried everything to get them in but destroyed them in the process) so had to reuse the original rivits (thank heavens they didn't break). It took me more time because of the oversized rivits but the microwave worked great now.