MH1150XMQ3 Whirlpool Microwave - Instructions

Wedged grill into open space and screwed in with existing screws

Not so sure this would qualify as "instructions", but I only needed a screwdriver because the "D" rings of the old vent filters broke off and I had to pry to old ones out. Keep in mind, I am mechanically disadvantaged and can barely change an A/C filter ... that being said, all I did for this order was input my Model number and PartSelect found the correct replacement part. I receive the parts super quick (faster than the other 2 purchases I did that day). The only bummer was the packaging ... super huge box for small tiny parts. Otherwise, I now know where to go for replacement parts. This project should be a "no-brainer" for most DYI's, so getting the right parts with just a model number was lifesaving for me :0)

Looked at the original instruction manual to see how it was installed, removed the two Phillips screws, fitted the grille into position until correct, then replaced the two screws.

Removed microwave case and bad part was right there in plain sight attached to the magatron. Two screws and two wires and part replacement was done. Plugged in microwave and works perfect. Couldn't have been any easier. Thanks for the easy troubleshooting and parts suggestions on your site.

With a phillips head screwdriver I removed the screws, which were screwed to the then non-existent grille, at the top of the grille holder, GENTLY popped the new grill into place and replaced the screws. It took about five minutes. As a housewife, I feel that doing these little repair jobs around the house saves my husband time and aggravation. It was all very simple, and I got the ordered part in two days. Fabulous!

This rental unit was missing the vent grille for the mounted microwave. It was super simple to install and makes the microwave look like new.

Removed the glass cover and replaced the bulb. Very simple.