MFI2067AES Maytag Refrigerator - Instructions

replaced electric control board, defrost for six hours. next day (24 hours) same problem, dusterhoff2928@charter.net

I removed all the neccesary shelves and drawers to get to the end cap, installed the replacement end cap and put the shelves, etc. back-finito!

After years of using a flash light to check the contents of my refrigerator, I decided to try to fix the problem myself. Replacing the light switch was very easy. The directions were straight forward and I'm sorry I waited so long to tackle the problem.

Took out 2nd new filter $43.00 each that clogged in less than 2 weeks each and installed in 2 mins. this bypass and ice and waterr work perfect.Thank you, thank you for your exceptional service ordered part and it came next day without extra charge,great service.

Just replaced a water/ice filter..

Very easy to replace the old broken piece with the new one. Simple

Simple! Pop the case open. Counterclockwise to remove old filter. Wipe out excess water. Unwrap new filter; remove tab. Place in filter holder; turn clockwise. Close case. Run water to remove air. Couldn't have been easier!

Unplug Refrigerator remove lower back panel to expose compressor.Unplug Capactor relay assembly,Plug in new start assenbly,and then the refrigerator to elect'outlet .Compressor srarted right up . Real easy fix simple tools to perform change out. Thanks!!! Saved a bunch of $$$$$ .

Was a snap. Took out the draws. Removed glass plate. Unscrewed endcap using socket set. Removed rail. Screwed rail to new endcap. Screwed in encap. Replaced all draws and plates. Didn't take more than ten minutes.

remove the screw on the right side (about 3). remove the screws holding onto the slider. disconnect the right side panel and bring the panel all the way forward so that the part connected to the rear of the refrigerator comes loose. replace new panel and put parts back together in reverse.

The pivot block looked slightly worn because the hinge door mechanism on the left door would not "close" when the door was opened. I bought the pivot block, but the fix is adjusting the dual french doors so they are even i n height at the top of the unit. Pivot block is a 2 minute job with screwdriver. Adjusting the height is a 5 minute job with nut driver.

The drawer and drawer frame needed to be replaced. The part arrived on time, was correct and the repair was very easy.

I pulled out the old crisper and put in the new one.. For the other, I had watched the video so I saw that you needed a nutdriver to remove the cap. It was easy.

I have now replaced both the left and the right side Pantry End Cap. The Left side is extremely easy, but the right side is a bit tricky due to the drawer temperature adjustment lever. This is a mecanical adjuster that is made of plastic pieces that are linked together. Not super difficult but requires a little studying while taking it apart so you get it back together the same way. All in all a very simple job ,

Removed crisper drawers, pantry lid, and rails. Removed pantry drawer. Unscrewed three bolts holding right end cap, and removed cap, taking care with temperature slide connection. Unscrewed (phillips head) drawer slide from end cap and removed temperature slide linkage and adjustment slide button. Installed linkage, slide button, and slide rail on new cap. Placed new cap in refrigerator, taking care to hook linkage into temperature slide. Reinstalled three bolts with nut driver. Reinstalled rails, pantry lid and crisper drawers.