MFI2067AES Maytag Refrigerator - Instructions

First off I had no idea how a fridge worked or where to begin and the troubleshooting section of the manual was a joke. So I took the back panel off made sure the coils underneath were clean. Took out the back panel of the freezer and made sure that nothing was frozen over and I hadn't seen excess water on the floor so ruled that out. I knew the condenser was still running so I took a shot in the dark. Ordered the part and waited for it to arrive. It took me 3 minutes to open the box and install it. Immediately knew it was working replaced the back panel and moved the fridge back.

Opened filter area door turned old filter to the left to unscrew. Took out old filter then replaced the new filter and turned it to the right to tighten it, closed cover and that was it all done.

It was very easy I just push ito n and it snaped right in.

I received the part very quickly in the mail, only 2 days later. I opened up the package and replaced the old try with the new tray and it was that simple! I couldn't believe that the replacement part only took one and a half days to get here. That was awesome! I have already used part select again and will continue to.

Replaced part--4 hexhead screws. This is my third time changing this part (right and left) and was happy to see that an obviously under-engineered design has been modified. The pin bracket has been reinforced and appears much stronger.The most time consuming portion of the fix was cleaning off the shelves for removal. Thanks for asking. Norm Notdurft

1. Unplugged refrigerator

2. Removed rear silver stainless steel panel on the right rear side of the refrigerator (if you are standing in front of the unit) using a small socket set. The panel is vertically located in center at the rear of the refrigerator.

4. Removed plastic cover over the HV controller board.

5. Unplugged 4 molex connectors attached to the board and carefully pushed on the plastic release locks that hold the board in place as not to break them and removed the HV controller board.

6. Inerted the new HV controller board and plugged in the molex connectors. All molex connectors are of unique size and will only attach to the HV controller board in one location.

7. Replaced plastic cover over HV controller board and attached stainless steel panel with a small socket set.

8. Plugged in the refrigerator.

9. Identified programming code inside the refrigerator.

10. Followed included instructions to enter program code to activate refrigerator front panel.

Received the grille and placed it in it's place. Not difficult at all.

self installled

Snapped the old one out and the new one in place. Only took about one minute.

Followed the instructions that came with the email(giving other people's experience with the replacent) indicating that the part had been shipped. It was quite easy and I am not very a good DIY person. Thanks for the information and instructions

I turned the water supply off and installed the new filter, which was easy. the hard part was finding the water filter at my local home improvement stores; they don't carry it. In the future I will use only Part Select.

Looked at the appliance's booklet to see how it fit together, then installed it.

PartsSelect makes it so easy. I love that they inlcude a picture of each part so I am sure I am buying the right thing!

went by instructions, used a little common sence.

Disengaged the hinges, removed old drawer lid. Engaged hinges on new drawer lid. Done