MFD2560HES Maytag Refrigerator - Instructions

Removed the 2 veggie drawer, removed the meat /pantry drawer and shelf. unscrewed the screws, removed the end cap and replaced it with new end cap - screwed the screws back in and voila - DONE!

Removed the 2 bins, glass shelf, large drawer. Removed the 2 screws holding the right drawer slide. Removed the 2 screws holding the pantry end cap in place. Transfered all the parts from the old end cap to the new end cap and reinstalled the end cap. Replaced the slide, glass shelf and the drawers. Installed the large drawer cover (very carefully!) as this is what broke off last time. Total time start to finish about 30 minutes.

Empty out freezer loosen two top screws and took out bottom screw. Lifted out ice maker and unplugged wire. Took bailing arm and plug and put on new ice maker and reverse the process. Had ice in three hours and no leaks.

The repair was simple. It was a matter of unpluging the old relay and then pluging in the new one. I almost bought a new refrigerator but after doing alittle reading on this web sight and finding out the most common reason for having the problem I was having I decided to order the relay. It was the problem...$ 70.00 -v- $1400.00. I'm HAPPY !

Was very easy after I found right tool to get out the screws. There were only 3 popped old one out and put new one in. I waited over a year thinking this was a difficult/expensive repair. So not true...22$ and 15 min. I will definitely recommend this store/site and maintain it for my future use.

Removed wiring from old ice maker and install on new. With 2 screws all ready in place hung ice maker on them. Attach wire connector into socket and install bottom screw to hold ice maker. Tighten top 2 screw and put wire guide in place. Drop wire guide down and ice started in 10 mins

had to replace side cap s because plastic pin sheared off

Found Board location and replacement instructions on Appliance Doctor website. Price there was actually 3 $30.00 cheaper.Had to remove light cover to access slots to insert a flat blade screwdriver which you use to depress tabs to unlock control board housing. It then swings down so you can unplug wiring harness's and remove and replace control board. Too early to tell if defrost is working yet.

I first reviewed the video, paying attend to the order in which items were removed and put back in place. On the video, I noticed that the lid to the draw was put back into place before the draw. Following these instructions, the repair went extremely easy and fast. I would recommend reviewing the video first.