MER6770AAW Maytag Range - Instructions

Unscrewed three screws securing the glass top. Lifted glass top and wedged it open. Took a picture of the current wiring. Removed old burner.Compared male contact points on new and old burner. Plugged new burner in appropriately. Note: The new burner is MUCH hotter than the old one.

Removed stove from slot in wall. Bent rear left leg would not unscrew due to bent metal bracket. Used hacksaw to cut out leg, then straightened metal bracket with small hammer and was able to screw new leg in and adjust height by using level on stove before reinserting stove its slot. Recheck level after pushing back in place and adjust front legs if necessary. If not for bent metal receiving bracket, would have taken much less time. Still easy tho. R'cvd part in two days. Very quick.

My husband removed the screws and pulled out the wires as far as he could. The hardest part was that he had a hard time getting to the back of the oven so I had to take over for him. I pulled out the wires so that I could see the connections and with a needle nose plier held the external part of the connection and pulled out the internal part with my fingers. Once the old element was disconnected on both sides, I put in the new element and pushed in the new connections. I pushed the 2 wires into the back of the oven, put the 2 screws in and - DONE. I think this was the easiest repair we have ever done. We always run into a problem - but not this time. I have to say that I did read some of the other descriptions that were written and they were very helpful.