Models > LWA60AL > Instructions

LWA60AL (PLWA60AL) Amana Washer - Instructions

All Instructions for the LWA60AL
136 - 139 of 139
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Water filled after machine off
Removed the plate screws. Found valve, unplugged wires, removed hose and replaced reattaching everything. Replaced plate. Done
Parts Used:
Water Inlet Valve Kit
  • Darcy from Merrill, WI
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers, Wrench set
Was this instruction helpful to you?
Thank you for voting!
Idler pulley bad, needs replaced
Repair went well using posted instructions. My advice is always replace pump as you will damage seal when pulling pump off shaft.
Parts Used:
Idler Pulley Wheel
  • Mark from Asotin, WA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Pliers, Socket set
Was this instruction helpful to you?
Thank you for voting!
Washer Had No Cold Water
Took off part and replaced it very easy instructions.
Parts Used:
Water Inlet Valve Kit Single Washer Inlet Strainer
  • lucinda from trilla, IL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Water leaking under the washer
Removed old hose, drained the water from the hose. Put new hose on.
Parts Used:
Drain Hose with Rubber Elbow
  • Laura from Westfield, MA
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Nutdriver
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the LWA60AL
136 - 139 of 139
Back to Top