LGA30AW (PLGA30AW) Amana Dryer - Instructions

removed front, top cabinet, drum, belt and motor. replaced idler pulley on motor. replaced motor, belt, drum and cabinet parts. test ran fine.

This is merely taking the old filter out and putting the new filter in. You will not find this part unless you go online or get lucky and find one in a used dryer. It is not necessary but I do recommend vacuuming the inside of the dryer beneath the filter. It is amazing how much lint can be in there.

I removed the top and front of the dryer then the lint filter housing and frame that holds in the drum then the drum belt and drum. Found that tha drive pulley was spining on ths shaft. I removed the fan cover, so I could remove the fan. I disconted wire harnsh and removed motor clamps from back and front of motor. Removed drive pulley and held shaft with a pare of chanellocks. I removed fan with 7/8 socket and impact drill.Then I replaced the motor by taking the motor frame out of the drier for easyer actess. Install fan on new motor by holding drive pulley with cressent while putting on fan with impact drill. Put motor in u shaped saddles making sure they are seated in the bottom. You may have to turn the barring a little. Then reinstale clamps. Put motor back in drier and put drier back togeather. simple saves money 144.00$ for motor and beld no labor. Ed from Mojve CA.

when I see its no gas flame, i deduct the flame sensor and the electric coils not fuction, I order tru partselect and that take me like 30 min. to remplaced those parts.