LDE7304ACE Maytag Dryer - Instructions

I took off the front panel of the dryer to access the tumbler drum . I took off the belt and removed the drum . I then replaced the two tumbler rollers . I also replaced the idler roller for the belt . I found it easier to put the belt on from the back of the dryer by taking off the small panel on the back to get access to the idler roller and motor pulley. I then installed the front panel . The dryer runs very smoothly now .

Replaced the Blower Wheel. It had been stripped by the axel due to the large amount of dirt, lint, etc that had accumulated in its housing and eventually restricted it from turning. The clip had come off as well.I had replaced the Drum Support roller kit previously. But, that did not resolve the noise issue.

Found a video online and followed the directions. I liked a tip that was given in the video and that was to take a digital picture of the wiring before disconnecting it. Then I referred back to it when I put it back together and it was easy.

the blower wheel was not turning with the shaft. so i figured the spline or D shaped bore was stripped. so i connect with partselect & read about it.i ordered the part from partselect and installation was not that hard at all.i wrecked the snap ring so go get the tool & make it easy on yourself. had the dryer purring in about one hour. thanks to partselect. jerry

simple as taking out the old filter and putting in the new one !the filter was here in three days .Great service , Thank you!

I diagnosed the problem with the dryer as being a bad blower wheel. Ordered the wheel and replaced easily. Removed front of dryer, removed front drum support and ductwork, removed wiring shield for heating element and then had full access to the blower wheel to replace. Used spring ring pliers to remove spring ring, then removed retaining clip for blower wheel. Wheel slipped off shaft easily and I was able to reverse process to replace the wheel.

I "Youtube'd" the model number and "make" and followed the simple instructions. This job was very easy. The symptoms pointed to either the drum rollers or the idler wheel so I replaced both while I was in there. I was able to do all with one "four-way" screwdriver, and didn't have to move the dryer out. I used snap ring pliers to remove the drum roller snap rings, but that could of been done with fine needle nosed pliers. While I had the drum out I used my shop vac to give the inside a good cleaning. I put it all back together and plugged it in and we couldn't believe how quiet it was.