Models > LAT2916AAM > Instructions

LAT2916AAM Maytag Washer - Instructions

All Instructions for the LAT2916AAM
436 - 439 of 439
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Moved in last week. No hot water in washer
Replaced the inlet valve and it worked perfectly. Very easy to do
Parts Used:
Water Inlet Valve
  • Simon from Newtown, AL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
Was this instruction helpful to you?
Thank you for voting!
belt had bad spot
real simple i just layed it down and replaced the belts DWIGHT SHAW PS. NO TOOLS REQUIRED.
Parts Used:
Belt Kit
  • Dwight f. from duncansville, PA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
agitor did not turn
tilted the machine back 45 degress. took both belts off and replaced them with the 2 new ones. put some tension on the drive belt and put the machine back in place, did a test run and it worked great.
Parts Used:
Belt Kit
  • william from buffalo grove, IL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
washer would spin but not drain
removed 2 screws holding on front panel,tilted machine back and remover belts checked stretch against new belts.stretch was minimal.removed 3 screws of pump from underneath machine.pump impeller was free slipping replaced pump installed new belts reattached front cover& started washing clothes again.less than 15 min to do everything
Parts Used:
Belt Kit Belt Kit
  • james from wildwood, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the LAT2916AAM
436 - 439 of 439
Back to Top