KUDV24SEAL3 KitchenAid Dishwasher - Instructions

I followed the PartSelect video that showed rotating the rack tine to the down position, then pushing that tine out of the two clips toward the right side of the rack. After removing the tine, push the broken clips off the drawer portion of the top rack. Installing the new clips on the drawer portion of the rack required a pair of pliers to snap the clip over the wire portion of the rack. Once the clips are in place, slide the tine removed earlier, horizontally into the clips. Rotate the tine upward until it snaps into the clip, fixing it in the upward orientation.

My model was DU7600XS0. I disassembled according to the video and the parts diagram here. I found a piece of metal, a pebble, and a wrecked drain impeller. I cleaned out all the debris and began reassembly. I found that the chopper blade shipped with this kit has a lip and will not fit over the metal drain impeller sleeve on this model. It needs to, or else it will not screw together properly and the impeller will not be able to turn. My old one was undamaged, so I used that instead. Also, the large black wash impeller has a shaft that is longer than the original part and because of that, it would not screw on. Again, the original wash impeller was fine, so I used the old one. I replace the gaskets and screwed everything else back together. It works great now. No water is left after the cycle anymore and the sound it makes is back to normal. Money well spent on this kit!