Quick Question!

Have you ever purchased from PartSelect.com before?

Models > KUDS30IXBL4 > Parts

KUDS30IXBL4 KitchenAid Dishwasher - Parts

All parts for the KitchenAid Dishwasher KUDS30IXBL4

Below is a list of all parts for the KitchenAid Dishwasher KUDS30IXBL4. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the KUDS30IXBL4
1-14 of 200
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$40.03

Rack Adjuster Kit - Left and Right Side

The rack adjuster connects to the dishrack and is used to change the height of the rack. This kit includes the parts to replace the left and right-side rack adjusters and has been ...

$21.17

Wheel

The lower dishrack wheel is used in a dishwasher to easily roll rack back and forth on the rails. To repair, open the dishwasher door and pull out the lower dishrack. Next, push the tab from both sides and it should pop out. To install the new wheel assembly, place it on the rack and make sure the caps overlap the wire from the inside before you clip it in place by pushing the wheel. Slide the rack back in the washer to make sure it is installed correctly. Refer to the manual provided by the manufacturer for further instructions.

$17.53

Door Balance Link Kit

This part is a door balance link kit, also sometimes known as door cable or door spring cable kit, that helps support the door as it opens and closes by connecting to the dishwashe...

$6.30

Rack Stop Clip

This part goes on the end of the rail to stop the dishrack from falling out.

$5.07

Tine Pivot

The tine pivot clip, also known as the tine row pivot, is used in dishwashers and is located in the upper dishrack. The clip is used to keep the tine row in place in the dishrack. ...

$17.71

Chopper Assembly

This part chops up/mince the food particles to prevent from clogging the dishwasher pump.

$11.43

Mounting Bracket

The mounting bracket is sold individually, without screws. This part secures the upper side of the dishwasher to the underside of the counter or cabinet to prevent the dishwasher f...

$31.93

Positioner

Also known as rack adjuster. Sold individually.

$26.28

Tine Row

The tine row on your dishwasher rack divides the rack into columns to keep your kitchen items in place during the washing cycle. If you notice that one or more of the tines on your...

$30.09

Drawer Track

$15.03

Spinner Kit

This is also called the 3rd-level spinner. This part works like a little spray arm at the top of your dishwasher.

$23.53

Adjuster Clip

Sold individually.

$4.89

Rubber Washer

The rubber washer is a part which is specific to dishwashers and should not be substituted by a similar part. It works with the heating element to seal the receptacle opening where...

$136.44

Circulation Pump and Motor

The circulation pump and motor is located near the bottom of the dishwasher. The part functions by spinning the impeller of the circulation pump, which is used to move the water through the spray arms during the wash cycle. Before you begin this repair, it is recommended that you pull your dishwasher out of the cabinet, so you can tip the dishwasher to one side and gain better access to the circulation pump and motor. Be sure to disconnect the power source and the water source to the dishwasher before you begin this repair. To complete this repair you will need a 1/4 inch nut driver and a 3/8 inch nut driver.

All Parts for the KUDS30IXBL4
1-14 of 200