KUDS01FLSS2 KitchenAid Dishwasher - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Old motor making lots of noise. Replace with new one!
Pulled out, put on it's side. Take pump off and put new one on and put all back together. Very easy. Video was helpful also.
Parts Used:
-
Kathy from Northfield, MN
-
Difficulty Level:Really Easy
-
Total Repair Time:1- 2 hours
-
Tools:Nutdriver, Screw drivers, Wrench set
Was this instruction helpful to you?
Thank you for voting!
upper and lower arm not spinning\ not cleaning properly
After inspection I found the rubber seals on the feed tube for the upper rack to be worn. At that point I thought that was it. I ordered the feed tube assembly the upper rack seal and the lower spray arm support hub as the bottom of the existing hub was worn. Installed all parts and same issue. Researched again on parts select and checked food chopper and it was clogged and broke off. Ordered and it works great. About 100.00 for parts and total time 1 to 1.5 hours as I worked on it three times. Down time about one week. This model is a Whirlpool Superba with the closest replacement about 1000.00 Thanks PART SELECT
Parts Used:
-
John from Bluffton, SC
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Not cleaning properly and loud noise
Followed the video and changed it out in 20 minutes which did not fix the problem entirely, but I went back to the list of symptoms and watched a video on exchanging the Chopper assembly. I disassembled the interior and found broken glass and wire and string restricting the rotational functions. No replacment was necssary here, but a good cleaning was in order. This made it run like new and the glasses came out shiny again. These step by step videos have even made me think about becoming an appliance repairman. LOL! This is about the 8th time I have had success with Part Select. I have had no failures. Thank you for giving away all the secrets. YOU DEFINITELY HAVE SAVED ME AND MY FAMILY TONS OF MONEY!
Parts Used:
-
Clark from Surprise, AZ
-
Difficulty Level:Easy
-
Total Repair Time:1- 2 hours
-
Tools:Nutdriver, Screw drivers, Wrench (Adjustable)
Was this instruction helpful to you?
Thank you for voting!
poor performance
I had turbo zone on my dishwasher. Stupidest thing ever. It just cut out the water going to the upper rack. This part got rid of turbo zone, and now my dishwasher works like a regular one (much better).
Parts Used:
-
george from Banning, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
Was this instruction helpful to you?
Thank you for voting!
Upper wash arm would not stay on
Snap in the upper wash arm and snap on the holding pin. Some bending required.
Parts Used:
-
Fredric from Ithaca, NY
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Dishwasher door would fall open, no spring tension.
Removed under countertop screws and lower trim plate. Retracted levelers to clear slate floor. Could only pull unit out about 8 inches, so had to reach in blind to remove and reconnect link ends from springs. Other than my 1 year old Newfoundland pup 'helping', no problems. Parts were perfect fit, just like in the video.
Parts Used:
-
Ralph from Ball Ground, GA
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers, Socket set
Was this instruction helpful to you?
Thank you for voting!