KUDI01DLSS6 KitchenAid Dishwasher - Instructions

I noted that the replacement kit had two large rollers now vs the original that had only one that rotated, the other fixed. Also, the plastic attachment for the door arm was more simple. It was very easy to pull out the unit, attach the spring end hook to the rear of the dishwaser frame hole, attach the new cable, thread it over the two rollers and pull the spring using the cable to attach to the door arms. Less than 20 minutes to install both sides.

Latch handle broke at each side. Beware in Model number of dishwasher that "I" looks an awful lot like "1" and there are both. Ordered the latch handle and it came in good time. Removal of the upper panel was just six T15 torx screws. Of course I didn't have that size, had to buy one. Remove the spring(s). I used small needle nose pliers. When apart it was clear I needed one of the small springs. Found one locally for six bucks. Both "legs" of the handle were broken. It came apart with a bit of figuring, new handle went on more easily than I expected but you have to see how it goes together. Installed the two small springs..be careful, I lost one for a few minutes..with small needlenose pliers. It all went back together easily when the new handle was put through the slot. Reinstalled panel.

Disconnected the water line after removing all the screws which hold the dishwasher in place. Slid the unit out around 24 inches and removed broken Door balance pulley and replaced both sides with the new door balance set . replaced both sides to ensure an even and balanced tension when opening and closing the door! Over all a relatively easy repair. Just be certain you disconnect the water line if you do not have enough slack when pulling out the unit from the cabinet. Good as new!

The video was excellent as was my experience when I replaced my ice maker.

Pulled out, put on it's side. Take pump off and put new one on and put all back together. Very easy. Video was helpful also.

put new one in

Followed the video and changed it out in 20 minutes which did not fix the problem entirely, but I went back to the list of symptoms and watched a video on exchanging the Chopper assembly. I disassembled the interior and found broken glass and wire and string restricting the rotational functions. No replacment was necssary here, but a good cleaning was in order. This made it run like new and the glasses came out shiny again. These step by step videos have even made me think about becoming an appliance repairman. LOL! This is about the 8th time I have had success with Part Select. I have had no failures. Thank you for giving away all the secrets. YOU DEFINITELY HAVE SAVED ME AND MY FAMILY TONS OF MONEY!

Removed under countertop screws and lower trim plate. Retracted levelers to clear slate floor. Could only pull unit out about 8 inches, so had to reach in blind to remove and reconnect link ends from springs. Other than my 1 year old Newfoundland pup 'helping', no problems. Parts were perfect fit, just like in the video.