KUDE48FXBL0 KitchenAid Dishwasher - Instructions

Pulled dishwasher out went down looked at problems ,saw both springs out of place and disconnected from door. Rewatched your video . Went to work one problem I did not realize the door had to be down to hook cable plastic attachment to door . Looked at video again saw door had to be down hooked up done !

Removed screws from under counter supports with Phillips head. With small flat head screwdriver removed the bottom plate, adjusted the support feet upwards . Very gently pulled out dishwasher from cabinet , about 2-2.5 feet exposing lower sides and springs and old balance parts. With a nut driver 5/16 removed first side old part keeping nut screw, placed the dual wheel part keyhole notch into the hole and positioned the bottom and loosely secured the lower portion back into the hole with the nut screw.Then with the cord replaced the narrow part over the metal holder the way the old one was. Carefully feed the cord over /under as before , tighten the nut screw into place take the ring end and and hook it on to the spring that is very tight and hard to pull into place. This was the hardest step as I needed help because of the heavy duty spring. My 7yo granddaughter hooked the ring as I need both hands on the spring. I checked the part for being screwed in correctly , then repeated on the other side. Carefully pushed the appliance back into cabinet making sure any cord, hoses had not been pinched, adjusted the front support legs back into place , secured the upper braces, replaced the lower plate and it is perfect! It works better than after I had a handy man do this a few years ago. I am a 64 yo woman!

My son Eric, read the directions and followed every instruction. Job was complete in less than 15 min. I filled dishwasher and set it to clean. Worked perfect and dishes came out sparkling. Thank you for you service. My ordered part was here overnight and instructions were easy and clear. Rebecca

I watched the video on the web site and made the very simple repair. It was so easy that almost anyone could do it. Also, the parts arrived 2 days after I ordered them. The whole process was very easy and saved the cost of a service call.

This was one of the easiest repair jobs I've done. The only reason it took over 15 minutes was because when I put the front cover back on I did not line up one side properly and had to take it off again. No big deal. This replacement part truly is just a plug and play replacement. Awesome!

snap it back in.

exactly as your great video suggested.thanks

Read comments on-line here. Then removed both drawers, removed one screw from top filler tube. Gently pulled tube down just enough to remove small "button", after first putting a cloth over entire bottom of dishwasher to catch it if it, or screw, fell. Button goes in "pointy side" down. Squeezed new spinner onto button until it "popped" on. Replaced top screw, drawers and ran a load. Worked perfectly. Button was worn out. Would be nice if only button could be purchased.