Quick Question!

Have you ever purchased from PartSelect.com before?

Models > KSRG25FKSS15 > Parts

KSRG25FKSS15 KitchenAid Refrigerator - Parts

All parts for the KitchenAid Refrigerator KSRG25FKSS15

Below is a list of all parts for the KitchenAid Refrigerator KSRG25FKSS15. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the KSRG25FKSS15
43-56 of 332
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$17.78

Water Fill Cup and Bearing

This refrigerator ice maker fill cup dispenses the water into the ice cube mold during the fill cycle. Replacing the water fill cup is a possible solution if you notice that the ic...

$22.41

Top Hinge - Right Side

$5.54

Screw

Sold individually.

$30.64

Thermostat Order 542369 Cement

The ice maker thermostat, also known as the cycling thermostat, controls and regulates the ice maker ejection cycle by monitoring the temperature inside the freezer to determine when to release the ice into the bin and start the ice making cycle again. If your ice maker is making unusual noises, or if the ice maker is not making or dispensing ice, there could be an issue with the thermostat. Before you begin this repair, make sure the power is disconnected from your refrigerator, and that any food that may spoil is safely stored. This is an OEM part and is sourced directly from the manufacturer. This thermostat is sold individually, and comes with two attachment clips.

$14.48

Coupling

This coupling is used for indoor ice dispensers.

$31.53

Dairy Compartment Door

$19.73

Door Hinge Set

Both bottom door hinges are included in this set.

$31.33

Water Filter Outlet Tube Kit

$5.44

Screw

Sold individually.

$39.86

GRILLE

$125.70

Fresh Food Door Gasket - Black

This door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

$95.74

Ice Mold

This is an ice maker mold and heater assembly for a refrigerator ice maker. It is used with modular style icemakers and is located in the freezer section of the refrigerator. This ice mold is flake resistant which prevents the coating on the mold from flaking into the ice cubes when the ice mold begins to wear. The ice mold forms the ice cubes and the heater allows the ice cubes to fall from the ice mold to drop them into the ice bucket. You will need to remove the ice maker from the refrigerator to access the mold and heater assembly. This is a genuine replacement part.

$42.08

Push-On Start Relay

The start relay briefly boosts the compressor, and then shuts off as soon as the motor gets up to speed.

$6.85

Dispenser Door Pin

This dispenser door pin comes with the washer.

All Parts for the KSRG25FKSS15
43-56 of 332