Quick Question!

Have you ever purchased from PartSelect.com before?

Models > KRFF15KSWHY0

KRFF15KSWHY0 KitchenAid Freezer - Overview

Get Parts and Repair Help for KRFF15KSWHY0

If you know the freezer repair part you need, you can browse the list of all parts on the KRFF15KSWHY0, or you can search by name or part description. You can also find your part by where it is located on the KRFF15KSWHY0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your freezer. We’ve also included any installation videos we have for KRFF15KSWHY0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the KRFF15KSWHY0

[Viewing 5 of 5]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.91

Light Bulb - 40W

Sold individually.

$40.25

Condenser Fan Motor Kit

This condenser fan motor operates in a clockwise fashion and carries carries 2W and 115V. It comes with screws, a mounting nut for the blade and a cushion. This part provides forced-air cooling for the condenser coil.

$7.20

Touch-Up Paint - White

18ml

$35.17

Light Socket Kit

The bulb is sold separately.

$46.85

Evaporator Fan Motor Kit

This refrigerator evaporator fan motor kit comes with a wiring harness and a four-inch push on fan blade.

$11.07

Spray Paint - 12 oz. - White

$50.21

Front Roller - Kit of 2

Support wheel assembly with bracket. Kit of 2.

$6.60

Touch-up Paint - Black

16ml

$110.71

Door Gasket

This door gasket is used to seal the freezer door when closed.

$20.81

Spray Paint - Surperior Black

This is a 12oz can of black spray paint.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

My refrigerator stopped cooling and the freezer section stopped freezing

  • Customer: garth from forest lake, MN
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 175 of 195 people found this instruction helpful
I knew the chances of all the freon leaking out was unlikely so I looked at the wiring to the compressor and there was a capacitor and a starter/overload so i figured I would start there. I went on line and found the parts at this site and they were less than the minimum service call charge for a service tech so I figured what the heck let's give her a shot ... read more

Sometimes the condenser fan would start causing the refrigerator to overheat.

  • Customer: Tom from Franklin, WI
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers
  • 124 of 132 people found this instruction helpful
Unplug the appliance.
Removed the screws holding the back panel.
Removed the fan blade.
removed 3 screws holding the condenser fan.
Remove the 3 metal brackets attached to the fan.
(First note which studs the brackets are attached to. Attach the 3 metal brackets to the new fan. (New screws were supplied)
Cut and strip the wire a... read more

Broken elbow on icemaker water fill tube.

  • Customer: Charles from Orland Hills, IL
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 102 of 111 people found this instruction helpful
Removed 2 screws holding water fill tube to rear of refrigerator and pulled out, matched old part with new to make sure of proper match. Guide new fill tube thru hole, making sure it is aligned with slot in ice cube tray on inside of freezer. Install new plastic line from water pump outlet to water fill tube, check for leaks, job done. read more