Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
replace burnt power cord
First I removed the back cover, two wires just unplugged and one wire I had to remove a screw, then put on the new wire, plug the two screws on, screw on the third wire and put the cover back on.
needed a new beater since old one was chipping and had coating flaking off.
Looked up part replacement, ordered on line. Found part easily and waited anxiously for new part. I wanted to make cookies for the holiday season. Received part quickly, opened up packaging, put on mixer and I was back in business. Thanks so much for an easy fix. I also was pleasantly surprised at how cheap the replacement part was. Thank you, thank you for allowing me to get a new part with ease and continue to use my Kitchen Aid mixer.
I actually didn't do the repair. I asked a friend who was a carpenter about what he thought was wrong with my mixer since it only had high speed which made mixing flour a snow storm. He said when his tools do that, it's the brushes. He ordered new ones and presto - my mixer works marvelously. He saved me from dumping a good mixer and $$$$$$$.
The mixer got a wad of dough between the pan & beater and stopped.
Once I looked at the schematic I was prtty sure what the problem was and what I needed to repair the problem. It was reltively easy to disassemble the mixer and immediately saw that I was correct in what was needed. I ordered the parts. They came through with no delay. It took almost as long to find all of the parts as it was to do the repair. In all it took about a half hour to repair, put it together and clean everything up. It works just like new.
remove the old screw and screwed the new part in place. I like your link because it shows a picture of the fixture and you can find the part you need real easy. Will order from you again when I need it.
just took the unit apart and replaced the worn gear and bracket . Then took the old worn gear and bracket apart and replaced the worn gear . Then put the assy back together and now I have a spare
I broke the motor brush when I was taking my mixer apart for some serious cleaning
unscrewed the screw holding the old brush. carefully removed the spring and old broken brush. we did have some of the old brush left inside, so my husband used a very thin drill bit to break it up. then carefully inverted the stand mixer to allow the broken pieces to fall out. then we were able to install the new brush. works great. yeah!!
Nut Screw Plastic Housing Split that stabilizes attachments on top side of machine
I removed the old screw with a hand tool to avoid injuring my hand. I then used my hand to install the new screw. Piece of cake. Ordering from Part Select was was a breeze. The only minor issue was the part cost $4.33 and shipping was $7.25.
first removed the dress ring by tapping it very gently.then drive the pin out that holds the beater plate on, now wiggle it off, then you can see the screws that hold the gear reducer on. remove them. take that off and you will see the housing that hold the worm gear. remove the 3 screws that hold it down . Now you will have to drive the drift pin out that holds the worm gear in place, slide the shaft out then remove gear. reverse order to assemble
My early '60's Kitchenaid K45 mixer screw cap/base plate would no longer hold the bowl, so I looked for another. This item, though not an exact replica of the original, fit and works great. The design is better by being more stout than the original. Pretty straightforward installation: remove three screws, take out old base plate, install new plate and screw down.
Very messy as there is lots of heavy grease inside the mixer and you have to fish out the blown gear parts. I vary glad I took shop class in High school as it preped me for the job. The machanical drawing you provide were very useful but you should mention the grease.
Mixer works just like new. and I got the parts in two days with standard shipping. Pizza on Thursday and fixed by Saturday