KBFS22EWMS7 KitchenAid Refrigerator - Instructions

Pulled out broken part, slid in new one, put drawers back in. Works great. Website to find and order part was super easy to use and part came quickly. Two thumbs up.

Clean off the glass shelf, remove drawers and shelf, pop in replacement rail, put everything back in fridge. Replacing the part is the easy part, what I would like to know is why this is the second one I have had to buy this year. There must be a problem with the replacement parts that they break so easily. This time, I bought 2, so that i have a spare - fortunately, the price is reasonable.

Opened filter area door turned old filter to the left to unscrew. Took out old filter then replaced the new filter and turned it to the right to tighten it, closed cover and that was it all done.

Purchased the new light switch, used a butter knife to pop the old one out, used the pliers to pull the wires off the metal tabs, replaced the new one with no problem. Took about under 1 minute. Lights are now all working.

Removed the drawers and shelf with glass t.op and center rail, installed new one (popped out and popped new one in). Took all of 5 minutes. Easy to order on line. Should use usps for shipping it is cheaper.

The instruction video was so helpful. I watched it before I ordered the part to be sure I was able to make the repair. The replacement part arrived quicker than I expected. Cleaning the shelf & bins was the most time consuming part of the job. The replacement part fit in place perfectly. My fridge is good as new again!

Removed the six screws holding the bottom access plate found at the rear of the refrigerator. This gives you easy access to the run capacitor that has a retaining clip. Remove the wire clip and pull out the capacitor (it has two quick disconnect terminals). Reverse the process using the new run capacitor to complete the repair.

I watched the on line you tube video on how to DIY. The putty knife worked to pop out the switch. I used the standar screwdriver to unplug the switch from the wire harness. Then plug in the new switch and pop it back in to the roof of the freezer. Tip: watch out when ordering the new switch - the freezer switch is different than the refrigerator switch. The freezer has three prongs. The fridge has two. I initially ordered the wrong part and added a week to the repair time and had to pay shipping to return the first switch.