JVM1630CH003 General Electric Microwave - Instructions

It was REALLY EASY finding the right parts using your diagrams..Thanks for your HELP!!I will definitely be back.Dan H

After reading reviews that there was no power what so ever and a fuse replacement will solve the problem, I tried it. Replacing the fuse is very easy (and I am not handy at all). All you have to do is remove the microwave cover from the top by removing two screws, slide the cover to the left and pulling the cover off. Then remove the grill in front of you, by removing one or two screws. The fuse is in front of you, use pliers and be firm but gentle. Replacing the fuse is easy but it did not solve my problem.

Removed microwave cover using screwdriver and anti tamper bit available at local hardware store. Megnetron had broken magnet making discovery of deffective part easy. Removed wire connector and three screws attaching magnetron to case, removed magnetron and installed new item in reverse order. Installed cover and made popcorn for operational check of microwave. Happy days..........

Ordering was easy and instillation even easier

PartSelect had helpful repair instructions on-line which made the repair easier and faster. Unfortunately, there were other problems with the oven that immediately blew the new fuse I had just installed. It was then determined that additional repair would most likely cost almost as much as a new microwave.

First unplugged the microwave, took top grill off, took control panel off, took wires off and used color coded tape to make sure they went back in right places, took fuse out and replaced it and put every thing back and it all worked fine and to top it off my wife did it all. So it was pretty easy.

I first read where someone had the same problem. Their solution was a burned-out fuse. I ordered a new fuse...installed it and that did not solve my problem. I revisted PartSelect and read how Marla (from Arlington, TX)solved her problem. I purchased a secondary switch and when it arrived, I made a copy of Marla's instructions and followed them to the letter. I installed the new secondary switch into the secondary space, put everything back together and the oven STILL DID NOT WORK. I had to take the latching panel apart again and test each switch to see if there was another bad one. I found that the third switch was burned out. So I took the new switch out of the second slot and installed it into the third slot. I tested the switches before reinstalling the latching panel. This time everything worked. So I put everything back together, reinstalled the microwave on the wall, tested it again, and everything worked perfectly.

Replace the fuses

Open vent, removed old filter, inserted new filter.

No repair involved, just replaced......looked online and ordered, thought it would take 4-5 days, came in perfect condition within TWO 2 days. awesomeness

I went on line, put in microwave repair and watched a video on repair. I then took the oven down from over the range and took it apart. I could see were the magnetron had burned out. There was a hole with obvious burn marks. I went on line looking for the needed part. I clicked on PartSelect and order the magnetron. I received the part within three days, regular shipping. As I had not put the oven back together it took only a few moments to save 150 to 200+ dollars. I put it back together and happy, happy me, it worked.

Replaced the tray.

Just like the directions said. Very simple.

01. Remove vent cover above door and lift door out of the two hinge pin holes.
02. Lay door face down on towel and insert putty knife between choke cover and frame. Pry gently inward (towards center of door), working all the way around choke cover until it pops out.
03. Remove screws securing door handle to frame and remove door handle.
04. Disconnect main door assembly from frame by gently prying (outward, using putty knife if needed) all clips securing main door assembly to frame.
05. Remove outer glass from frame.
06. Analyze new frame for excess plastic trim (leftover from molding process), especially under and around all slots that will hold outer glass, and remove excess trim with utility knife.
07. Slide outer glass under slots at the top of the frame first. Push glass under slots as far as you can by hand.
08. This is the most difficult step: gently pry (outward, using your fingers) the tabs on the slots at the bottom of the frame until glass slips under these slots. Take your time and work back and forth, slot by slot.
09. Slide glass (using your fingers) under the slots on the right side of the frame. There are also two smaller slots on the left side of the frame (one at the top and one at the bottom). Make sure glass is seated under these slots as well.
10. Turn frame over and check that outer glass is seated against frame (no significant gaps between glass and frame) all the way around.
11. Insert main door assembly into frame and push down (using your fingers) all the way around main door assembly until all clips have engaged, securing main door assembly to frame.
12. Insert door handle into frame and secure door handle with screws.
13. Insert choke cover into frame and push down (using your fingers) all the way around until choke cover is secured in frame.
14. The top of the frame may look bowed upward in the center, indicating that the outer glass may need to be better seated in the frame. To eliminate any bow at the top, place door on its bottom on a carpeted floor and have someone hold door. Place towel on door, place wood block on towel, and gently tap wood block with rubber mallet until bow was been eliminated.
15. The bottom of the frame may look bowed downward in the center, indicating that the outer glass may need to be better seated in the frame. To eliminate any bow at the bottom, place door on its top on a carpeted floor and have someone hold door. Place towel on door, place wood block on towel, and gently tap wood block with rubber mallet until bow was been eliminated.
16. Align the two hinge pins with the two hinge pin holes on the microwave and put door back on.
17. Install vent cover above door.
18. Microwave some popcorn, grab your beverage of choice, and bask in the savings and satisfaction of doing it yourself! I hope this helped.

open box and installed