Models > JGS9900BDB

JGS9900BDB Jenn-Air Range - Overview

Get Parts and Repair Help for JGS9900BDB

If you know the range repair part you need, you can browse the list of all parts on the JGS9900BDB, or you can search by name or part description. You can also find your part by where it is located on the JGS9900BDB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for JGS9900BDB parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.76

Grate Foot

Sold individually.

$15.84

Burner Electrode

This part has a male spade and helps your burner ignite and produce flame. If a wire lead is needed, you can purchase locally.

$2.70

Screw

Sold individually.

$52.75

Bake Igniter

This part ignites to help bake your food.

$2.70

Igniter Screw

This screw is sold individually.

$2.70

Screw

This screw is sold individually.

$38.09

Burner Head with Electrode

$2.70

Screw

This screw is sold individually.

$32.11

Door Gasket

This oven door gasket comes with built in retaining clips.

$33.80

Burner Head

This part includes the spark igniter.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Ignitor stopped working on gas cooktop

  • Customer: Jeff from Lake Orion MI
  • Difficulty: Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Pliers, Screw drivers, Wrench set
  • 43 of 43 people found this instruction helpful
As others reported, there are 2 torx screws that need to be removed so that the burner element can be removed. One came out with a little effort, the other one did not as it was corroded. After breaking a torx bit, a second torx bit succeeded in breaking off the screw head. This then required a drill to drill out the broken shaft and then rethreading the s... read more

Ignitor was bad on upper oven

  • Customer: David from Temple Terrace FL
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 31 of 36 people found this instruction helpful
First I removed the lower tray and all parts covering the ignitor on the upper oven. 2. Then I removed the screws holding down the ignitor and flame distributor. 3. I then had to pull out the oven from the wall and remove the back panel to expose the wires connecting the ignitor. This required the removal of about six screws but they were fairly easy to ... read more

The ceramic insulator on the burner ignitor cracked & the spark shorted so that the burner would not ignite.

  • Customer: Loren from San Luis Obispo CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 23 of 25 people found this instruction helpful
Firts I removed the 2 screws that held the burber in place. Then I lifted the burner up & disconnected the wire that connected to the ignitor. Then I removed the one screw that held the ignitor to the burner. I then reversed these steps, replacing the cracked ignitor with the new one, replaced the screw holding it to the burner, then reconnected wire, return... read more