Quick Question!

Have you ever purchased from PartSelect.com before?

Models > JGC9430BDR

JGC9430BDR Jenn-Air Cooktop - Overview

Get Parts and Repair Help for JGC9430BDR

If you know the cooktop repair part you need, you can browse the list of all parts on the JGC9430BDR, or you can search by name or part description. You can also find your part by where it is located on the JGC9430BDR by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$17.73

Burner Electrode

This part has a male spade and helps your burner ignite and produce flame. If a wire lead is needed, you can purchase locally.

$5.00

Screw

Sold individually.

$5.10

Screw, 8/18 x 3/8

This screw is sold individually.

$64.29

Cap, Burner (RF) (Black)

$16.28

Conversion Kit - NG - LP

This kit is used to convert from natural gas to liquid propane.

$177.40

Spark Module

This is a 4-point re-ignition spark module. NOTE: This part has been redesigned by the manufacture, it may appear different but will still function the same.

$43.21

SWITCH- BU

$96.28

Gas Pressure Regulator

This valve automatically cuts off the flow of gas when it reaches a certain pressure.

$27.66

GASKET- FI

$30.17

SWITCH- BU

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Ignitor stopped working on gas cooktop

  • Customer: Jeff from Lake Orion, MI
  • Difficulty: Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Pliers, Screw drivers, Wrench set
  • 58 of 58 people found this instruction helpful
As others reported, there are 2 torx screws that need to be removed so that the burner element can be removed. One came out with a little effort, the other one did not as it was corroded. After breaking a torx bit, a second torx bit succeeded in breaking off the screw head. This then required a drill to drill out the broken shaft and then rethreading the s... read more

The ceramic insulator on the burner ignitor cracked & the spark shorted so that the burner would not ignite.

  • Customer: Loren from San Luis Obispo, CA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 27 of 29 people found this instruction helpful
Firts I removed the 2 screws that held the burber in place. Then I lifted the burner up & disconnected the wire that connected to the ignitor. Then I removed the one screw that held the ignitor to the burner. I then reversed these steps, replacing the cracked ignitor with the new one, replaced the screw holding it to the burner, then reconnected wire, return... read more

Burners kept clicking after ignited

  • Customer: Robert from Ranchos de Taos, NM
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 13 of 14 people found this instruction helpful
This problem was driving me crazy for months. Of course, after I bought and installed the part and it still was not fixed I finally found a website that told me how to fix the clicking. The problem is that the removable head burners (#8 on the top assembly diagram) are not making good electrical contact with the base burners (#22). What I did was grab the he... read more